General Electric Dryer Valves

M Series Ignition Coil Kit

Part Number: 5303931775

The gas dryer ignition coil set comes with two ignition coils: one three-terminal boost/hold coil, and one two-terminal secondary coil. If it takes too long to dry or there is no heat, the coils may be bad and will need to be replaced. When the coils go bad they will not hold the gas valve open properly. Usually only one of them burns out but you should replace them as a set. Both must be operational for the gas valve to open. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.

M-Series Primary Dual Coil Gas Valve

Part Number: WE4X692

This 'M' series coil is both a boosting as well as a holding coil. It has three terminals.

M - Series Secondary Coil - 2 Terminals

1 Review

Part Number: WE4X693

This part is the replacement main valve coil for your dryer. It is black and white in color and has 2 terminals. It is approximately 1 inch long and 1 inch wide. The main valve coil opens the gas valves while the dryer is running. This coil is used with two coil gas shut off valve assemblies. Be sure to turn off the gas before you begin this repair. This part is sold individually and is a genuine OEM part sourced directly from the manufacturer.

Natural Gas to Liquid Propane Conversion Kit

Part Number: WE25X217

This conversion kit changes the dryer from natural gas to liquid propane. Installation instructions are included.

2-Coil Gas Shut-Off Valve Assembly

Part Number: WE14X215

NG to LP Conversion Kit

Part Number: WE03X23918

Liquid Propane to Natural Gas Conversion Kit

Part Number: WE25X218

This conversion kit changes the dryer from liquid propane to natural gas. Installation instructions are included.

BURNER ASM.

Part Number: WE14M104

Burner Tube

Part Number: 134197700

VALVE & PIPE Assembly

Part Number: WE11X20711