General Electric Ice Maker Hoses and Tubes

Water Tube Kit

1 Review

Part Number: W10823511

The water tubing is made of plastic and goes between the water valve and the back of your refrigerator. The tubing is 72-inch in length, 1/4 inch in diameter, and comes with 2 inserts. This tube may be longer than the original tube and may need to be cut to fit your appliance. The water tube transports water to the ice and water dispensers. If there is no water going to the ice maker, your refrigerator is leaking, or if the ice and water dispensers are not dispensing properly, you may need to replace this tube kit. This part is an OEM part directly from the manufacturer. Please remember to shut off the water supply and to disconnect the power to your refrigerator before starting your repair.

Ice Maker Water Distributor Tube

Part Number: W10863947

The water distributor tube distributes water from the reservoir to the evaporator plate.

Water Line - 1/4"

Part Number: WR17X1948

The ice maker water line is used to direct and supply water to the ice maker during the fill cycle. This waterline is located on the back wall of your refrigerator/freezer, is made of plastic and is 1/4” in diameter. If the water line becomes damaged it could cause water to leak on the floor and the tubing will need to be replaced. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

Tube, Water

Part Number: WP2313745

Reservoir Hose

Part Number: WP2185626

Hose, Overflow

Part Number: WP2313890

TUBE

Part Number: WR17X12914

TUBE

Part Number: WR17X10456