General Electric Washer Drums and Tubs

Drum Bearing Slide - White (Sold individually)

4 Reviews

Part Number: WE1M504

This single white drum bearing slide attaches to the outer-most sides of the bearing to help support the front of the drum as it rotates. If your dryer is making loud noises or the drum will not tumble, you many need to replace the slides. The manufacturer recommends replacing both slides at the same time; there are 2 slides per dryer. This is a genuine OEM part. Please make sure to disconnect power to the dryer before starting your repair.

Drum Bearing Slide - Green (Sold individually)

1 Review

Part Number: WE1M1067

This single green drum bearing slide attaches to the outer-most sides of the bearing to help support the front of the drum as it rotates. If your dryer is making loud noises or the drum won?t tumble you many need to replace the slides. The manufacturer recommends replacing both slides at the same time. There are 2 slides per dryer. This is a genuine OEM part. Please make sure to disconnect the power to the dryer before starting your repair.

Drum Glide Bearing - White (Sold individually)

Part Number: WE3M51

Upper Drum Glide

2 Reviews

Part Number: 5303937139

The upper drum felt glide kit helps to support the front drum as it rotates smoothly and quietly while operating. This kit includes three glides with the adhesive. If your dryer won’t tumble or is noisy, the glide could be worn down causing you to hear a metal on metal noise and will need to be replaced. The drum glide is a genuine OEM part and sold individually. Please remember to disconnect the power to the dryer before starting your repair.

Inner Tub Base Hub

1 Review

Part Number: WH45X10027

This part is the replacement inner tub base hub for your washer. It is made of metal and is approximately 15 inches in diameter. The inner tub base hub fits between the wash tub and the spin basket, and it holds the spin basket on the gear case shaft. The main reason you would want to replace the hub, is if the washer will not agitate, or if you notice excessive noise or shaking when the washer is in use. Be sure to disconnect the washer from the water and power sources before you begin this repair. This part is sold individually and is and OEM part from the manufacturer.

Outer Tub

Part Number: WH45X20473

This part holds the water during the wash cycle and houses the spin basket.

RING BALANCE Assembly

1 Review

Part Number: WH45X10138

TRUNNION

Part Number: 131545101

This part helps with the spinning and agitating cycles.

COVER TUB Assembly

Part Number: WH45X10134

BASKET Assembly

Part Number: WH45X10090