General Electric Washer Springs and Shock Absorbers

Tub Dampening Strap

Part Number: WH1X2727

This part is used to support the tub and keep it in the center of the cabinet to reduce vibration. If your washer is making loud noises, or shakes or moves, one or more of the straps may have broken. It is recommended to replace all 4 tub dampening straps at the same time. This part is sold individually.

DAMPER ASSEMBLY

Part Number: WH01X10727

This is a replacement shock absorber for your washer. The shock absorber is approximately 9 inches long and a little more than one inch wide. It is black and silver in color, and is sold individually. There are four shock absorbers on your washer, and they support the tub and prevent it from shaking around. If your washer is shaking or making a lot of noise during operation, you may need to replace the shock absorber. It is important to determine if you have one or more shock absorbers that need replacement before you begin the repair. This is an OEM part from the manufacturer.

Suspension Rod and Spring Assembly

1 Review

Part Number: WH16X544

This part is the replacement suspension rod and spring assembly for your washer. The rod is approximately 27 inches long and is sold individually. The suspension rod and spring works something like a shock absorber and prevents the washer tub from shaking too much while the washer is operating. If you notice excessive shaking or vibrating, or if you notice a strange sound while the washer is running, you may need to replace the suspension rod and spring assembly. This is an OEM part sourced directly from the manufacturer.

Rod and Spring Assembly - Green

Part Number: WH16X10057

This part helps center and support the drum, transmission and motor assembly.

Suspension Rod and Spring

Part Number: WH16X543

This part is the replacement suspension rod and spring assembly for your washer. The rod is approximately 27 inches long and is sold individually. The suspension rod and spring works something like a shock absorber and prevents the washer tub from shaking too much while the washer is operating. If you notice excessive shaking or vibrating, or if you notice a strange sound while the washer is running, you may need to replace the suspension rod and spring assembly. This is an OEM part sourced directly from the manufacturer.

Front Suspension Rod & Spring Assembly - Blue

Part Number: WH16X10158

Sold individually. This part is used to keep your tub upright and somewhat level during the different cycles.

Socket Rod Support - White

Part Number: WH01X10001

This part is a replacement socket rod support for your washer. The socket rod support is found at the top of the washer frame in the front part of the washer. It supports the suspension rod, so the rod can prevent the tub from shaking too much during operation. If your washer is shaking excessively or emitting an odd sound during use, it may be because the rod support is broken, and the suspension rod is not able to do its job. This part is made of white plastic and is sold individually.

Rear Suspension Rod & Spring Assembly - Red

Part Number: WH16X10159

Shock Absorber with Pin

Part Number: WH01X10343

Sold individually. This part helps stop your washer from shaking uncontrollably during a spin cycle.

ROD AND SPRING Assembly

Part Number: WH16X10175