Hotpoint Washer Hoses and Tubes

Drain Hose

10 Reviews

Part Number: WH41X10096

This corrugated drain hose carries the drain water from the washer to the house drain. It is black in color, measures 57-inches long, and both ends of the drain hose can be bent. If your drain hose becomes damaged or cracked, it will cause water to leak on the floor during the wash cycle and you will need to replace the hose. This is a genuine OEM part. Please make sure you shut off the water supply and disconnect the power to the washer before starting your repair. Note: Clip is not included.

Pump to Tub Inlet Drain Hose

1 Review

Part Number: WH41X22935

This replacement inlet drain hose connects your washer's water pump to its tub. This hose is seven and a half inches in length and only two inches wide.

Water Pressure Switch Hose

Part Number: WH41X365

This is a water pressure switch hose, also known as the air dome tube, for your washer. It is made of clear plastic and is sold individually. The hose transports water to your water pressure switch, so the switch can control how much water enters the washer during a cycle. If your washer will not fill up with water, or if water continues to fill the tub even after it is full, you may have a damaged water pressure switch hose. Inspect the hose for cracks and leaks, and if the hose is damaged you will need to replace it.

Water Fill Nozzle

Part Number: WH41X10077

This part is the replacement water fill nozzle for your washer. It is white and tan in color, made of plastic, and is approximately 7 inches long and 4 inches wide. The water fill nozzle is also known as the water inlet assembly and directs the fill water into the tub. Over time the nozzle can become cracked and damaged, and this can cause it to leak. A damaged nozzle will need to be replaced. Be sure to disconnect the water supply to the washer before you begin this repair. You should also determine if any of the other parts that transport water into the washer are leaking, including the water inlet hose, and if they need to be repaired as well. This part is sold individually and is a genuine OEM part.

Drain Hose - Pump to Cabinet

Part Number: WH41X374

HOSE DRAIN Assembly

Part Number: WH41X25457

Hose Clamp Kit

Part Number: WH1X2036

This hose clamp kit contains two clamps. The smaller of the two is an inch in diameter while the larger of the two is two inches in diameter.

Drain Hose Extension with Adapter and Clamp

1 Review

Part Number: WH49X301

2PK-POLYMER COATED 4'HOS

Part Number: PM14X10005

HOSE DRAIN

Part Number: WH41X324