Inglis Dishwasher Hardware

Wash Arm Retainer Nut

7 Reviews

Part Number: WP9742945

Use this part to secure the lower spray arm of your dishwasher.

Rubber Washer

Part Number: WP717273

The black heating element washer goes between the heating element and the dishwasher tub to form a seal where the element attaches to prevent water from leaking during its cycle. If the washer goes bad it will cause water to leak out on to the floor. This part is made of rubber, measures approximately 1” in diameter and is sold individually. This is a genuine OEM part.

Retainer Clip - White

Part Number: WPW10503549

This part is used to hold the access panel in place. Sold individually.

Grommet

Part Number: WPW10538166

Torx Screw

Part Number: WP3368921

7-18 x 3/4" - sold individually.

Cover Screw

Part Number: WP308685

Sold individually.

Screw - 8-18 x 1/2

3 Reviews

Part Number: WP302868

Sold Individually.

Hose Clamp

Part Number: WP596669

This hose clamp expands from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag washing machines to secure the end of the drain hose to the pump drain port. Please make sure to disconnect the power to your washer before you start your repair. This hose clamp is a genuine OEM part and is sold individually.

Hose Clamp

Part Number: WP285655

This single hose clamp is used to hold the water hose in place on the pump, to avoid the hose or pump from leaking water. If you notice your washer leaking you may need to replace the clamp. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

CLAMP

Part Number: W10789434