International Washer Springs and Shock Absorbers

Snubber Ring

1 Review

Part Number: WP21002026

The snubber ring works in conjunction with your washing machine by helping to reduce noise and vibration during operation. The snubber ring fits between the leg and washer base. It is white in color, and measures approximately 8 1/2” in diameter. If your washer is making a loud noise or shakes a lot during use, the snubber ring may need to be replaced. Disconnect the power and water supply before beginning your repair. This is a genuine OEM part.

Damper Pad Kit

Part Number: 203956

This damper pad kit is used for base support. It comes with three six inch damper pads, two little tubes of lubricant. NOTE: This part will need adhesive to stick it in place.

Motor Pivot Spring

Part Number: WP22004376

This part is the replacement motor pivot spring for your washer. It is made of metal and is approximately 3 inches long and 2 inches wide. The motor pivot spring helps hold the drive motor in the correct position on the motor plate. If your drive motor shakes during use, if the pumps will not operate, or if your washer is excessively loud during operation, you may need to replace the motor pivot spring. Be sure to disconnect the washer from the power source before you begin this repair. This part is sold individually and is an OEM part sourced directly from the manufacturer.

Tension Springs -Set of 2

Part Number: 202718

This is a set of 2 tension springs.

Glide and Spring Kit

1 Review

Part Number: 205000

This glide and spring kit contains two three inch springs, four one inch square glides, and two tubes springs. This kit replaces older style round roller glides.

Timer Knob Spring

Part Number: WP211065

This timer knob spring is almost an inch and a half long, and is not quite an inch in diameter. It is made of metal and is used with the timer knobs of both washers and dryers.

Lid Switch Actuator Spring

Part Number: WP213720

This lid switch actuator spring is exactly one inch long. It is made of metal.

Brake Spring

Part Number: WP21001910

Unbalanced Plunger

Part Number: WP216255

When this part is used along with the lid switch, it can tell the motor of the washer to stop when a load is uneven. The washer will not start up until the lid is opened and then closed again.