Jenn-Air Washer Parts
Find Your Appliance Parts

Search by part or model number

Need help finding your Model Number?

Jenn-Air Washer Parts

Transmission Pulley and Bearing Kit

Part Number: 12002213

The transmission pulley and bearing kit, also known as a thrust bearing kit, is located on the drive shaft. If your washer won’t agitate during use, drum won’t drain, or there is a loud noise during operation, you may need to replace this part. A worn bearing also causes slow spinning or no spin at all. This kit includes the pulley that rotates to spin the tub, washer, and thrust bearing that fits between the pulley and the transmission shaft, 2 upper race washers, 1 lower race washer and the instruction sheet. This is a genuine OEM kit; the parts are not available separately. Please remember to disconnect the power and water supply to the washer before starting the repair.

Easy Part #:

EAP2003651

Availability:

In Stock

Your price

$52.16

Drive Belt - 51 inches long

(2)

Part Number: WP21352320

This V-style drive belt is about 51-inch long and 3/8-inch wide. This part is made to slip onto the motor pulley to bring the basket up to the speed required. The belt encounters wear and tear over time. If your washer will not drain, spin, or agitate, you may need to replace your belt. It is recommended to disconnect the power to your washer before you start your repair. This V-style belt is a genuine OEM part.

Easy Part #:

EAP11738882

Availability:

In Stock

Your price

$7.09

Drain Pump with Pulley

(2)

Part Number: WP35-6465

This drain pump with pulley has 2 ports. The pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period. If your washer will not drain, is noisy, leaking or has a burning smell, you may need to replace the drain pump. This is a genuine OEM part. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair.

Easy Part #:

EAP11741799

Availability:

In Stock

Your price

$67.58

Lid Hinge

Part Number: WP35-2044

The lid hinge attaches to the lid of your washer to allow the lid to pivot open and closed when in use. This part is the female end of the lid hinge. The lid hinge is an inch and a half long. It is all white in color and is made entirely of plastic.

Easy Part #:

EAP11741780

Availability:

In Stock

Your price

$5.56

Lid Hinge Pin

Part Number: WP35-2045

The lid hinge pin allows the lid to pivot open and closed correctly. This part is the male end of the lid hinge. If the lid is not opening or closing properly you may need to replace the lid hinge pin on your washer. This lid hinge pin is just over an inch long. It is all white in color and is made entirely of plastic.

Easy Part #:

EAP11741781

Availability:

In Stock

Your price

$12.13

Hose Clamp

Part Number: WP285655

This single hose clamp is used to hold the water hose in place on the pump, to avoid the hose or pump from leaking water. If you notice your washer leaking you may need to replace the clamp. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

Easy Part #:

EAP11740613

Availability:

In Stock

Your price

$6.05

Inlet Hose - 5 FT

(1)

Part Number: WP89503

This hose can handle hot or cold water and is five feet long.

Easy Part #:

EAP11746820

Availability:

In Stock

Your price

$9.27

Motor Pivot Spring

Part Number: WP22004376

This part is the replacement motor pivot spring for your washer. It is made of metal and is approximately 3 inches long and 2 inches wide. The motor pivot spring helps hold the drive motor in the correct position on the motor plate. If your drive motor shakes during use, if the pumps will not operate, or if your washer is excessively loud during operation, you may need to replace the motor pivot spring. Be sure to disconnect the washer from the power source before you begin this repair. This part is sold individually and is an OEM part sourced directly from the manufacturer.

Easy Part #:

EAP11739525

Availability:

In Stock

Your price

$5.81

Belt Kit

(1)

Part Number: 12112425

There are two belts under a Maytag washer; one for the main drive pulley and one for the water pump. The belt kit includes both the drive belt and the pump belt which are both V-shaped. The belt connects the drive motor to the drive system to be able to spin the tub basket. If your washer will not agitate, not spin, or not drain, the belt could be worn or damaged and will need to be replaced. This is a genuine OEM kit. Please remember to disconnect the power and shut off the water supply to your washer before starting your repair.

Easy Part #:

EAP2005284

Availability:

In Stock

Your price

$30.19

Plastic Motor Pulley

(1)

Part Number: WP21001108

This motor pulley is only an inch high and is two and a half inches in diameter. It is all black in color and is made entirely of plastic.

Easy Part #:

EAP11738804

Availability:

In Stock

Your price

$14.25

Jenn-Air Washer Parts

ABOUT SSL CERTIFICATES
1-877-910-4617
Daily 8am to 10pm ET
Contact Us