1034327520 Kenmore Cooktop Parts List

Drip bowl - 6 inch (6 in burner bowl)

This six-inch chrome drip bowl is intended for use with rolled terminal-style plug in surface element units. The drip bowl sits under the burner to catch anything that may spill over to make cleaning up spills quick. This is a genuine OEM part and is sold individually.

Drip bowl - 8 inch (8 inch burner bowl)

The chrome drip bowl is located under the burner element to catch anything that may spill over to make cleaning up spills quick. This drip bowl is eight inches in size and is intended for use with rolled terminal style plug-in surface element units. This is a genuine OEM part and is sold individually.

Surface burner terminal block kit (terminal block w/wire leads)

The surface burner terminal block kit comes with a terminal block, wire nuts, heat shrink protective tubing, and wires. This part is used to connect the wire harness to the surface burner element. If your element will not heat at all, or if it is not heating properly, it is likely an issue with the terminal block and it will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power supply before starting your repair.

Ignitor mounting screw (screw 10-32 x 1/4)

Sold Individually.

Scw 8abx.250 (screw 7-32 x 5/16)

Control seal (seal, infinite heat control, 2 reqd.)

Screw-pkg 12 (screw 10-32 x 7/16)

Discontinued (catch, 2 reqd.)

Discontinued (hinge, lt. Or rt.)

Discontinued (g. M. Screw 8-32 x 1/4)

Nut (keps nut 8-32)

Sold individually.

Screw (g.M. Screw 8-32 x 3/8)

Identification plate (208 volt identification plate)

U-shaped speed nut (2 required for key 183) (speed nut)

Harness & conduit