1034347211 Kenmore Cooktop Parts List

Drip bowl - 6 inch (6 in burner bowl lt front, rt rear)

This six-inch chrome drip bowl is intended for use with rolled terminal-style plug in surface element units. The drip bowl sits under the burner to catch anything that may spill over to make cleaning up spills quick. This is a genuine OEM part and is sold individually.

Drip bowl - 8 inch (8 in burner bowl rt front, lt rear)

The chrome drip bowl is located under the burner element to catch anything that may spill over to make cleaning up spills quick. This drip bowl is eight inches in size and is intended for use with rolled terminal style plug-in surface element units. This is a genuine OEM part and is sold individually.

Surface burner terminal block kit (terminal block)

The surface burner terminal block kit comes with a terminal block, wire nuts, heat shrink protective tubing, and wires. This part is used to connect the wire harness to the surface burner element. If your element will not heat at all, or if it is not heating properly, it is likely an issue with the terminal block and it will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power supply before starting your repair.

Ignitor mounting screw (screw)

Sold Individually.

Control seal

Screw

Speed nut

Discontinued (catch)

Discontinued (hinge, lt or rt)

Discontinued (screw)

Nut

Sold individually.

Screw (g.M. Screw)

Discontinued (g.M. Screw)

Terminal block bracket, for #40 not illust (bracket, terminal)

6 in. Surface unit-208v-when converting to 208v also order 237665 208 volt identification plate (208v - when converting to 208v service also order 237665 identification plate)