1034348610 Kenmore Cooktop Parts List

Drip bowl - 6 inch (bowl-burner 6" (lt. Front & rt. Rear))

This six-inch chrome drip bowl is intended for use with rolled terminal-style plug in surface element units. The drip bowl sits under the burner to catch anything that may spill over to make cleaning up spills quick. This is a genuine OEM part and is sold individually.

Drip bowl - 8 inch (bowl-burner b" (rt. Front & lt. Rear))

The chrome drip bowl is located under the burner element to catch anything that may spill over to make cleaning up spills quick. This drip bowl is eight inches in size and is intended for use with rolled terminal style plug-in surface element units. This is a genuine OEM part and is sold individually.

Infinite heat switch kit (lt. Front & rt. Rear)

The infinite switch controls the stove top surface burner. This switch will work with most of the electrical range models with coil burner elements.

Surface burner terminal block kit (block-terminal w/wires)

The surface burner terminal block kit comes with a terminal block, wire nuts, heat shrink protective tubing, and wires. This part is used to connect the wire harness to the surface burner element. If your element will not heat at all, or if it is not heating properly, it is likely an issue with the terminal block and it will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power supply before starting your repair.

Screw (screw 10-32x7/16")

Sold Individually.

"8"" trim ring " (8" burner ring (2 required))

"6"" trim ring " (6" burner ring (2 required))

Scw 8abx.250 (screw 7-32x5/16")

Pan-large (8" burner pan (2 required))

Canning element (240 volt)

6 inch porcelain gray bu (6" burner pan (2 required))

Control seal (seal-control)

Medallion (medallion (4 req.))

Hinge-top (hinge-main top)

Sup rod clmp (clamp)