1034358210 Kenmore Cooktop Parts List

Drip bowl - 6 inch (6 in burner bowl lt. Front rt. Rear)

This six-inch chrome drip bowl is intended for use with rolled terminal-style plug in surface element units. The drip bowl sits under the burner to catch anything that may spill over to make cleaning up spills quick. This is a genuine OEM part and is sold individually.

Drip bowl - 8 inch (8 in burner bowl rt. Front lt. Rear)

The chrome drip bowl is located under the burner element to catch anything that may spill over to make cleaning up spills quick. This drip bowl is eight inches in size and is intended for use with rolled terminal style plug-in surface element units. This is a genuine OEM part and is sold individually.

Infinite heat switch kit (infinite heat control 4 required)

The infinite switch controls the stove top surface burner. This switch will work with most of the electrical range models with coil burner elements.

Surface burner terminal block kit (terminal block w/wire lead 4 required)

The surface burner terminal block kit comes with a terminal block, wire nuts, heat shrink protective tubing, and wires. This part is used to connect the wire harness to the surface burner element. If your element will not heat at all, or if it is not heating properly, it is likely an issue with the terminal block and it will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power supply before starting your repair.

Screw (screw 10-32 x 7/16 in)

Sold Individually.

Ind light (indicator light)

Scw 8abx.250 (screw 7-32 x 5/16 in)

Control seal (control seal 4 required)

Discontinued (g.M. Screw 8-32 x 1/4 in)

Nut (keps nut 2 required)

Sold individually.

Red lens-for key 29 (lens-indicator light)

Strike-rt. Or lt. (strike 2 required)

Knob-infinite control 4required (knob-infinite control 4 required)

Mounting plate-conduit

Identification plate (208 volt identification plate)