1065858782 Kenmore Refrigerator Parts List

Ice dispenser kit motor - 120v 60hz (auger motor for refrigerator ice dispenser. This auger motor pushes ice through the dispenser chute. If your auger motor is defective, the dispenser w)

This motor rotates the auger. When the auger rotates, it pushes ice out of the bin, through a chute to the user.

Inlet hose washer (gasket, water inlet hose)

The high-pressure inlet hose washer is black in color. It is one inch in diameter, made of rubber, and used with many washing machines, refrigerators, and dishwashers. The washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged and will need to be replaced. This is a genuine OEM part and is sold individually.

Bottom kickplate clip (clip for bottom grill)

This clip is sold individually.

Dispenser door pin (pin kit, dispenser door)

This dispenser door pin comes with the washer.

Heater, defrost (defrost heater)

The heater is located at the bottom of the evaporator. The defrost heater heats the evaporator in the defrost mode of operation. The thermostat must be replaced when replacing the defrost heater.

Wire shelf (shelf, upper)

Sold individually.

Rear roller (support wheel assembly with bracket, rear)

Sold Individually.

Soleniod assembly (cube/crushed ice solenoid assembly)

This part consists of a cube and arm that upon activation opens the ice container gate and allows the ice cubes to enter into the chute and into the ice and water dispenser.

Ice stripper (ice stripper for icemaker)

This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold. Once removed from the mold, the ice pieces are then deposited into the ice bucket ready to be dispensed. If your ice maker is not making any ice you may need to replace this part. The part is white in color and is approximately 9-inch long. The ice stripper is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Single hex head screw (screw 1/4" hex head, 10-12 x 1/2)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Shelf support kit (shelf support pins, slide-on, set of 4)

This kit is enough for one right and one left support. There are 2 different styles of supports in this kit.

Egg container

This part is used to hold eggs.

Coupling (icemaker bin auger coupling)

Rear compressor cover (rear panel unit cover)

Used to cover up the compressor components.

Strain relief (dispenser tubing strain relief)

Sold individually.