10659512290 Kenmore Refrigerator Parts List

Shelf support kit (shelf support pins, slide-on, set of 4)

This kit is enough for one right and one left support. There are 2 different styles of supports in this kit.

Coupling (icemaker bin auger coupling)

Rear compressor cover (rear panel unit cover)

Used to cover up the compressor components.

Strain relief (dispenser tubing strain relief)

Sold individually.

Ice maker front cover (ice maker module front cover)

Door shelf trim (top door shelf bar- freezer door)

Sold individually.

Water inlet valve - 3 coil (water inlet valve)

This part releases water from the supply line when it's activated.

Condenser fan blade - steel (condenser fan blade, steel)

This fan blade circulates air over the condenser. It mounts onto the shaft of the condenser fan motor.

Trim, meat pan (meat pan trim)

Air diffuser assembly (refrigerator air diffuser assembly)

This air diffuser controls the amount of cold air distributed through the refrigerator.

Torsion spring (ice dispenser door spring)

Found in the dispenser section of your appliance. Can also be found in the ice door kit.

Air baffle (baffle, ice dispensing bucket)

This air baffle is used to redirect the air threw to the tunnel and on to the ice mold.

Speed nut

The speed nut works in conjunction with the condenser fan motor. The fan blade attaches to the condenser motor shaft and the speed nut secures the blade to the motor. Make sure the speed nut is properly attached and secured. If the part is damaged, worn, or will not tighten, you will need to replace it. This part measures 1/4-20 inch. Sold individually. Please remember to disconnect the power to the refrigerator before starting your repair.

Freezer defrost tube heater kit (refrigerator defrost drain strap kit to prevent the drain tube from freezing. This kit only applies to Whirlpool built top freezer refrigerators. No l)

Also known as heat probe. This part prevents drain freeze-ups.

Adhesive cement (alumilastic cement)

Also known as Alumilastic Cement.