1069630211 Kenmore Refrigerator Parts List

Rear roller (support wheel assembly with bracket, rear)

Sold Individually.

Ice stripper (ice stripper for icemaker)

This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold. Once removed from the mold, the ice pieces are then deposited into the ice bucket ready to be dispensed. If your ice maker is not making any ice you may need to replace this part. The part is white in color and is approximately 9-inch long. The ice stripper is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Single hex head screw (screw 1/4" hex head, 10-12 x 1/2)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Freezer door gasket (freezer door gasket {31 1/2" x 18 1/2"}, white)

This white door gasket is used to seal the freezer door when closed.

Shelf support kit (shelf support pins, slide-on, set of 4)

This kit is enough for one right and one left support. There are 2 different styles of supports in this kit.

Crisper drawer support - cut-to-fit (crisper support)

This part may be longer than the original - it might need to be cut to the correct size for your appliance.

Touch-up paint - black (black appliance touch-up paint.)

16ml

Bottom door hinge with pin (door hinge, bottom w/pin)

Sold individually.

Sheet metal screw (flat head sheet metal screw)

Sold individually.

Ice maker front cover (ice maker module front cover)

Cold control thermostat (thermostat, refrigerator. Note: Poor cooling problems are normally not the result of a thermostat problem.)

The cold control thermostat helps maintain the proper temperature. When the refrigerator reaches the desired temperature, this part interrupts the flow of electricity to the compressor which stops the cooling process. If the refrigerator is too warm you may need to replace the control thermostat. This part has a temperature range from 29.5 degrees Fahrenheit to 16.5 degrees Fahrenheit and a capillary length of 35 inches. This is a genuine OEM part. Please remember to disconnect the power to your refrigerator before starting the repair.

Door handle spacer (spacer, top)

Sold individually.

Side hinge plate

Speed nut

The speed nut works in conjunction with the condenser fan motor. The fan blade attaches to the condenser motor shaft and the speed nut secures the blade to the motor. Make sure the speed nut is properly attached and secured. If the part is damaged, worn, or will not tighten, you will need to replace it. This part measures 1/4-20 inch. Sold individually. Please remember to disconnect the power to the refrigerator before starting your repair.

Touch-up paint - almond (almond touch-up paint)