10641519100 Kenmore Refrigerator Parts List

Bottom kickplate clip (clip, grille)

This clip is sold individually.

Heater, defrost (heater)

The heater is located at the bottom of the evaporator. The defrost heater heats the evaporator in the defrost mode of operation. The thermostat must be replaced when replacing the defrost heater.

Wire shelf (shelf wire)

Sold individually.

Rear roller (cabinet roller)

Sold Individually.

Overload and relay assembly (overload)

This kit comes with the compressor relay, overload and cover.

Touch-up paint - black (tuchup)

16ml

Egg container (container egg)

This part is used to hold eggs.

Single handle (handle)

Sold individually.

Bracket, door stop (black) (bracket)

Condenser fan blade - steel (fan blade)

This fan blade circulates air over the condenser. It mounts onto the shaft of the condenser fan motor.

Screw

This screw is sold individually.

Trim, meat pan (pan trim)

Air diffuser assembly (diffuser)

This air diffuser controls the amount of cold air distributed through the refrigerator.

Cantilever shelf - glass included (cantilever shelf)

This part includes the frame and glass. This shelf can be moved according to the space you need. These shelves are supported at the back of the refrigerator.

Speed nut (nut)

The speed nut works in conjunction with the condenser fan motor. The fan blade attaches to the condenser motor shaft and the speed nut secures the blade to the motor. Make sure the speed nut is properly attached and secured. If the part is damaged, worn, or will not tighten, you will need to replace it. This part measures 1/4-20 inch. Sold individually. Please remember to disconnect the power to the refrigerator before starting your repair.