1064211173 Kenmore Beverage Parts List

Icemaker control assembly (module, assembly)

This part is used to help tell the icemaker what to do - it turns the timing cams and the ejector blades. It also controls the heater, the water inlet valve, the cube size, and cube ejection. The control assembly is located under the white cover of the ice maker. If the ice maker is making too much ice or not making ice at all, you may need to replace the control assembly. The motor is not sold separately. This is a genuine OEM part. Please make sure you disconnect power to the refrigerator before starting your repair.

Water fill cup and bearing (bearing & inlet)

The ice maker fill cup and bearing dispenses the water into the ice mold during the fill cycle. If your ice maker is not making ice, is leaking, or the cup or bearing is cracked, you will need to replace this part. This part is three inches long, white in color, and is made of plastic. It is a genuine OEM part. Please remember to disconnect the power and water supply to your refrigerator before starting the repair.

Ice mold (mold & heater assembly)

This ice cube mold and heater assembly has a flake resistant surface with separations that mold eight ice crescents and is used with modular style icemakers on some refrigerators. The mold heater is an electrical device that thaws the ice quickly, so it can be released from the icemaker mold. If your ice maker is not making ice you may need to replace this part. Please remember to disconnect the power and water supply before starting your repair.

Arm-shut (shut off arm (for side x side models with ice dispenser))

Cycling thermostat (thermostat)

The ice maker thermostat, also known as bi-metal device, regulates and controls the activation of the icemaker ejection cycle. The thermostat lets the ice maker know when it is cold enough to produce ice. If your ice maker is not making ice or not dispensing ice, you may need to replace the thermostat. This is a genuine OEM part and comes with two retaining clips. Please remember to disconnect power to your refrigerator before starting your repair.

Ice stripper

This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold. Once removed from the mold, the ice pieces are then deposited into the ice bucket ready to be dispensed. If your ice maker is not making any ice you may need to replace this part. The part is white in color and is approximately 9-inch long. The ice stripper is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Ice maker front cover (cover)

Screw (screw, (3))

Sold individually.

Shut off arm (shutoff arm)

The shut off arm works in conjunction with the ice maker in your refrigerator. When the shut off arm is high enough the ice maker will shut off and no more ice will be produced until the level of ice in the bin drops. The ice maker can be turned off by lifting the arm all the way to the top until in a locked position. This part is made of metal, and measures approximately 9 inches wide and 4 inches in height.

Ejector arm (ejector)

This arm is used to eject the ice from the icemaker into the bin.

Ice maker wire harness (wiring, harness)

This wire harness has a flat connector.

Screw (screw, 8-32 x 27/64)

This screw is sold individually.

Motor housing (support)

Retainer, thermostat (retainer, thermostat (2))

Bracket