10644023600 Kenmore Refrigerator Parts List

Screw

Sold individually.

Ice maker cover bracket (bracket)

This is the replacement ice maker cover bracket for your refrigerator. It is made of white plastic and is approximately 5 inches wide and 2 inches long. The ice maker cover bracket holds and supports the ice maker cover. If the ice maker cover is loose or missing, you may need to replace the bracket. You will also want to replace the bracket if it will not stay in place, or if it is cracked or broken. To replace the cover bracket, simply remove the ice maker cover, then use a ¼ inch nut driver to loosen and remove the bracket. Screw in the new bracket and replace the cover to complete your repair. This is an OEM part that is sold individually.

Cntrl-elec (microcomputer)

This set of two electronic control boards contains both the emitter and the receiver. These boards tells the icemaker when it's full and that it has to dump the ice, and it also tells the icemaker when to refill with water.

Screw

Sold individually.

Bottom kickplate clip (clip, grille)

This clip is sold individually.

Dispenser door pin (door hinge pin)

This dispenser door pin comes with the washer.

Screw

This screw is sold individually.

Grille - bisque (grille)

Lever, ice dispenser (white) (arm dispenser)

Also known as Lever.

Touch-up paint - black (tuchup)

16ml

Lever, water dispenser (white) (arm dispenser)

This lever activates the controls to distribute ice and water.

Egg container (egg bin)

This part is used to hold eggs.

Filter cap - apollo gray (filter cap)

Cap covers the water filter.

Socket

This light socket is a genuine OEM part for your refrigerator. The light socket powers the bulb that lights your fridge. To repair this part, you will need to remove the screws holding the control panel in place. Pull the panel out and unplug any terminals or wires connected to the socket. Plug the new socket into place, and reattach terminals and wires.

Touch-up paint - biscuit (tuchup)