10644029603 Kenmore Refrigerator Parts List

Cycling thermostat (thermostat)

The ice maker thermostat, also known as bi-metal device, regulates and controls the activation of the icemaker ejection cycle. The thermostat lets the ice maker know when it is cold enough to produce ice. If your ice maker is not making ice or not dispensing ice, you may need to replace the thermostat. This is a genuine OEM part and comes with two retaining clips. Please remember to disconnect power to your refrigerator before starting your repair.

Coupling

Sold individually.

Shelf support (stud assembly)

Sold individually.

Screw

Sold individually.

Single shelf stud (shelf stud)

This part screws into the side of the wall in your fresh food compartment and supports a shelf.

Screw

Sold individually.

Levers retainer/clip (clip)

This part is the replacement dispenser lever retainer for your refrigerator. It is made of metal and is approximately 2 inches long and ½ an inch wide. The bottom half of the dispenser lever retainer holds in the pivot points of the ice and water arms. If it breaks, the arms will be loose and can shake around. The top half springs the ice and water arms back into the original position, and if the retainer is broken, they will not be able to do this. The dispenser lever retainer is found behind the dispenser trim and can be removed with a ¼ inch nut driver. This part is sold individually and is an OEM part.

Roller and eyelet - kit of 2 (roller)

Light socket kit (light socket)

The bulb is sold separately.

Installation screw (screw)

This screw is sold individually.

Washer, coupling (washer)

This washer is sold individually.

Screw

Sold individually.

Ice maker cover bracket (bracket)

This is the replacement ice maker cover bracket for your refrigerator. It is made of white plastic and is approximately 5 inches wide and 2 inches long. The ice maker cover bracket holds and supports the ice maker cover. If the ice maker cover is loose or missing, you may need to replace the bracket. You will also want to replace the bracket if it will not stay in place, or if it is cracked or broken. To replace the cover bracket, simply remove the ice maker cover, then use a ¼ inch nut driver to loosen and remove the bracket. Screw in the new bracket and replace the cover to complete your repair. This is an OEM part that is sold individually.

Cntrl-elec (microcomputer)

This set of two electronic control boards contains both the emitter and the receiver. These boards tells the icemaker when it's full and that it has to dump the ice, and it also tells the icemaker when to refill with water.

Screw

Sold individually.