10644109300 Kenmore Refrigerator Parts List

Ice maker cover bracket (bracket, ice maker cover)

This is the replacement ice maker cover bracket for your refrigerator. It is made of white plastic and is approximately 5 inches wide and 2 inches long. The ice maker cover bracket holds and supports the ice maker cover. If the ice maker cover is loose or missing, you may need to replace the bracket. You will also want to replace the bracket if it will not stay in place, or if it is cracked or broken. To replace the cover bracket, simply remove the ice maker cover, then use a ¼ inch nut driver to loosen and remove the bracket. Screw in the new bracket and replace the cover to complete your repair. This is an OEM part that is sold individually.

Water dispenser lever - white (lever, water dispenser (white))

Once a glass is pressed against the actuator pad it will cause the dispenser to deliver water when activated.

Ice dispenser arm - white (lever, ice dispenser (white))

Once a glass is pressed against the actuator pad it will cause the dispenser to deliver ice when activated.

Water filter cap (cap, water filter (white))

The water filter cap fits onto the end of the water filter to cover the end and hold the filter in place.

Dispenser door pin (pin)

This dispenser door pin comes with the washer.

Heater, defrost

The heater is located at the bottom of the evaporator. The defrost heater heats the evaporator in the defrost mode of operation. The thermostat must be replaced when replacing the defrost heater.

Screw

This screw is sold individually.

Egg container (egg bin)

This part is used to hold eggs.

Bin button - blue (button, bin)

Start relay combination (overload (production))

Start relay and overload for production compressor only. The start relay boosts the compressor, and then shuts off as soon as the motor gets up to speed. The overlay provides added protection against excessive current and against excessive temperature use.

Strain relief

Sold individually.

Range screw (screw)

This screw is sold individually. 8-18 x 3/8

Washer

Water line (tube, filter inlet)

The Water Tube is an OEM component specifically designed for Whirlpool refrigerators. This 1/4" outer diameter water tube provides a pathway for water to flow through the refrigerator's internal components during operations like ice production. This water tube can be cut to fit, is approximately 24 1/2" long.

Single flat spacer (spacer, flat)

This part works in conjunction with the blades for the ice maker.