10644262600 Kenmore Refrigerator Parts List

Cabinet mount screw (screw)

Sold Individually - 2 screws needed to mount each handle.

Evaporator drip tray (tray)

This is the replacement evaporator drip tray for your refrigerator. It is made of white plastic and is approximately 19 inches by 9 inches. The evaporator drip tray sits below the evaporator to collect dripping water. If the drip tray is damaged, you may notice that your refrigerator is leaking. Because it is made of plastic, the drip tray can eventually develop a crack. You will need to pull out the refrigerator from the wall, and take off the bottom panel on the back of your refrigerator in order to access the drip tray for replacement. This is an OEM part sourced directly from the manufacturer.

Fan grommet (grommet)

Sold Individually - Appliance originally takes 2.

Electronic defrost control board with wire harness and screws (defrost timer)

This part is located in the control box in the refrigerator.

Door hinge set (door hinge)

Both bottom door hinges are included in this set.

Bottom kickplate clip (clip, grille)

This clip is sold individually.

Rear roller (cabinet roller)

Sold Individually.

Condenser fan motor (motor-cond)

This fan motor circulates the air through the refrigerator grille and cools the compressor and condenser coils. It also helps to evaporate extra water in the drain pan. Please note: If the original fan motor has 3 terminals please order part number W10204250, otherwise order this part (WP2188874).

Touch-up paint - black (tuchup)

16ml

Fresh food door gasket - misty beige (gasket panel)

This door gasket is used to make an air-tight seal for the cabinet when the door is closed.

Touch-up paint - biscuit (tuchup)

Light cover lens (light lens)

Shelf-wire (shelf wire)

Sold individually. Appliance normally takes 2.

Bracket, door stop (black) (bracket)

Screw

This screw is sold individually.