10648064894 Kenmore Refrigerator Parts List

Installation screw (screw)

This screw is sold individually.

Cabinet mount screw (screw)

Sold Individually - 2 screws needed to mount each handle.

Evaporator drip tray (tray)

This is the replacement evaporator drip tray for your refrigerator. It is made of white plastic and is approximately 19 inches by 9 inches. The evaporator drip tray sits below the evaporator to collect dripping water. If the drip tray is damaged, you may notice that your refrigerator is leaking. Because it is made of plastic, the drip tray can eventually develop a crack. You will need to pull out the refrigerator from the wall, and take off the bottom panel on the back of your refrigerator in order to access the drip tray for replacement. This is an OEM part sourced directly from the manufacturer.

Fan grommet (grommet)

Sold Individually - Appliance originally takes 2.

Compressor start device kit (start-dev)

This kit includes the Relay, Overload and cover. The start relay briefly boosts the compressor, and then shuts off as soon as the motor gets up to speed and the Overload provides added protection for the compressor motor because, in addition to protecting against excessive current, it also protects against excessive temperature use.

Door hinge set (door hinge)

Both bottom door hinges are included in this set.

Bottom kickplate clip (clip, grille)

This clip is sold individually.

Rear roller (cabinet roller)

Sold Individually.

Touch-up paint - black (tuchup)

16ml

Fresh food door gasket - misty beige (gasket panel)

This door gasket is used to make an air-tight seal for the cabinet when the door is closed.

Egg container (container egg)

This part is used to hold eggs.

Touch-up paint - biscuit (tuchup)

Compressor relay and overload kit (overload)

The overload protects a motor from overheating and the relay boosts the compressor.

Endcap - left side (endcap)

Single handle (handle)

Sold individually.