Parts for Kenmore Models 10650027004

Spray paint - 12 oz. - white (spray)

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

Easy Part #:: EAP347819

Availability:: In Stock

Price:: $18.90

Floating baffle (baffle)

This ice auger support, also known as a baffle, is a manufacturer-approved replacement part for your refrigerator ice maker. This part can become cracked or damaged, preventing your ice auger from doing its job. This repair requires extensive disassembly; take photos as you go to make reassembly easier. To replace this part, life the ice door out of the way and life the ice arm into the off position. Pull out the ice bucket and use a 1/4 inch nut driver to remove the screws holding the ice container and connecting rod in place. Pry the e-clip and washer off the bottom of the auger assembly. Use a 9/16ths wrench to remove the nut at the bottom of the auger. Pull off the auger teeth assembly and replace the auger support with your new part. Now you can begin reassembling.

Easy Part #:: EAP11731223

Availability:: In Stock

Price:: $25.31

Screw

This screw is sold individually.

Easy Part #:: EAP11742755

Availability:: In Stock

Price:: $12.18

Water inlet valve - 120v (inlet valve)

This water inlet valve is for the ice maker and water dispenser in the refrigerator. To remove outlet tubing, depress ring that the tube slides into. Please remember to disconnect the power and water supply to the refrigerator before starting the repair.

Easy Part #:: EAP11731255

Availability:: In Stock

Price:: $89.98

Cycling thermostat (thermostat)

The ice maker thermostat, also known as bi-metal device, regulates and controls the activation of the icemaker ejection cycle. The thermostat lets the ice maker know when it is cold enough to produce ice. If your ice maker is not making ice or not dispensing ice, you may need to replace the thermostat. This is a genuine OEM part and comes with two retaining clips. Please remember to disconnect power to your refrigerator before starting your repair.

Easy Part #:: EAP11743313

Availability:: In Stock

Price:: $53.34

Door light switch (light switch)

The white door light switch is in the control panel section of your refrigerator. The light will turn on when you open the door. If the light doesn?t turn on when the door is open the contacts in the switch could be burnt out and will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power to your refrigerator before starting your repair.

Easy Part #:: EAP11738900

Availability:: In Stock

Price:: $26.83

Shelf support (stud assembly)

Sold individually.

Easy Part #:: EAP12578346

Availability:: In Stock

Price:: $13.11

Single shelf stud (shelf stud)

This part screws into the side of the wall in your fresh food compartment and supports a shelf.

Easy Part #:: EAP11739228

Availability:: In Stock

Price:: $8.07

Dispenser grille (grille)

This white overflow grille is located on the bottom of the ice/water dispenser.

Easy Part #:: EAP327871

Availability:: No Longer Available

Screw

Sold individually.

Easy Part #:: EAP11742754

Availability:: In Stock

Price:: $7.37

Levers retainer/clip (clip)

This part is the replacement dispenser lever retainer for your refrigerator. It is made of metal and is approximately 2 inches long and ½ an inch wide. The bottom half of the dispenser lever retainer holds in the pivot points of the ice and water arms. If it breaks, the arms will be loose and can shake around. The top half springs the ice and water arms back into the original position, and if the retainer is broken, they will not be able to do this. The dispenser lever retainer is found behind the dispenser trim and can be removed with a ¼ inch nut driver. This part is sold individually and is an OEM part.

Easy Part #:: EAP11739183

Availability:: In Stock

Price:: $9.13

Thimble top (thimble)

For white, biscuit, black and stainless models.

Easy Part #:: EAP11739043

Availability:: In Stock

Price:: $10.37

Light socket kit (light socket)

The bulb is sold separately.

Easy Part #:: EAP371236

Availability:: In Stock

Price:: $64.67

Compression nut (nut-compre)

This single 1/4-inch compression nut is used to connect the lines that supply water to the correct components, the water dispenser and the ice maker, with the plastic water line of the icemaker assembly. This is a genuine OEM part. Please remember to disconnect the power and water supply to the refrigerator before starting your repair.