1065907890 Kenmore Refrigerator Parts List

Bi-metal defrost thermostat (refrigerator defrost thermostat. The thermostat clips onto the evaporator.)

If ice is building up in your freezer or if your freezer is getting too warm on the defrost cycle you may need to replace the bi-metal thermostat.

Relay-strt (start relay)

The start relay briefly boosts the compressor, and then shuts off as soon as the motor gets up to speed.

Speed nut

The speed nut works in conjunction with the condenser fan motor. The fan blade attaches to the condenser motor shaft and the speed nut secures the blade to the motor. Make sure the speed nut is properly attached and secured. If the part is damaged, worn, or will not tighten, you will need to replace it. This part measures 1/4-20 inch. Sold individually. Please remember to disconnect the power to the refrigerator before starting your repair.

Screw - 8-18 x 1/2 (screw)

Sold individually.

Condenser fan blade

This fan blade circulates air over the condenser. It mounts onto the shaft of the condenser fan motor.

Defrost heater assembly (heater, defrost)

The defrost heater keeps the cooling coils from frosting over.

Evaporator/drain pan (defrost drain pan)

This tray is used to collect the access water from the cooling system to prevent water from leaking on to your floor.

Terminal cover (terminal cover, service compressor only)

Covers Relay/Overload on the Compressor

Fan, motor bracket (bracket insert)

Terminal cover (cover, terminal)

Clip, heater (clip)

Clip

Wire assembly (production) (wire harness, capacitor)

Evaporator

Condenser (condenser assembly)