106736300 Kenmore Dehumidifier Parts List

Hose clamp (clamp, hose)

This hose clamp expands from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag washing machines to secure the end of the drain hose to the pump drain port. Please make sure to disconnect the power to your washer before you start your repair. This hose clamp is a genuine OEM part and is sold individually.

Water inlet hose washer (washer, drain pan)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Humidistat kit (humidistat)

Screw (screw, 8 x 1/4)

This screw is sold individually. Size: 8-32 x 1/4 inch.

Filter drier tube (tube & strainer inc. Illus. 42)

The filter drier tube with system access port, works in conjunction with your refrigerator by filtering the refrigerant that travels through the seal system of your refrigerator. This part measures approximately 10” long and is a genuine OEM part. Please make sure to disconnect the power before starting the repair. Please note it is recommended to have a service technician install the filter drier tube because it involves recharging and recovering refrigerant in the sealed refrigerant system.

Screw

Sold individually.

Seal-strip (seal)

Discontinued (motor)

Seal-rail (seal)

Cord-power (cord, service)

Screw (2) (screw, 10 x 3/8)

Hose, presure switch (hose, pressure switch)

Wiring harness compressor (wire, harness compressor service)

Screw (screw, 8 x 3/8)

Strainer