1067690260 Kenmore Refrigerator Parts List

Screw (screw, 8 x 5/8)

This screw is a little under an inch long and is made of metal. It is used with a refrigerator's ice maker assembly. Sold individually.

Retainer bar end cap (cap, end)

Sold individually.

Freezer door gasket (gasket, door freezer)

This white door gasket is used to seal the freezer door when closed.

Speed nut (nut, speed, 1/4-20)

The speed nut works in conjunction with the condenser fan motor. The fan blade attaches to the condenser motor shaft and the speed nut secures the blade to the motor. Make sure the speed nut is properly attached and secured. If the part is damaged, worn, or will not tighten, you will need to replace it. This part measures 1/4-20 inch. Sold individually. Please remember to disconnect the power to the refrigerator before starting your repair.

Evaporator/drain pan (tray, evaporating)

This tray is used to collect the access water from the cooling system to prevent water from leaking on to your floor.

Screw (screw, 8-32 x 3/8)

This screw is sold individually.

Screw - 8-32 x 1-1/4 (screw, 8 x 13/16)

Sold individually.

Crisper shelf support stud - white (stud, shelf)

Sold Individually.

Capacitor (capacitor, used on start kit 482398)

Condenser fan blade (blade, fan)

This fan blade circulates air over the condenser. It mounts onto the shaft of the condenser fan motor.

Cover (slide & cover, pan)

Bimetl-def (bimetal, defrost)

Filter drier tube (drier)

The filter drier tube with system access port, works in conjunction with your refrigerator by filtering the refrigerant that travels through the seal system of your refrigerator. This part measures approximately 10” long and is a genuine OEM part. Please make sure to disconnect the power before starting the repair. Please note it is recommended to have a service technician install the filter drier tube because it involves recharging and recovering refrigerant in the sealed refrigerant system.

Cold control slide (slide, cold control)

Clip (clip, air duct)