10688419100 Parts List

1-15 of 114

Dryer thermal fuse (thermal fuse)

This part is a one-time use thermal fuse which attaches to the blower wheel housing of your clothes dryer. The fuse acts as a safety mechanism that will stop the flow of electricity to the motor when the dryer overheats. If your dryer will not start or there is no heat or not enough heat, you may need to replace the thermal fuse. The fuse cannot be reset and must be replaced when there is no longer continuity between the pins. Terminal size is 3/16. This is a genuine OEM part. Disconnect the power to your dryer before starting your repair.

Easy Part #:

EAP11741460

Availability:

In Stock

Price:

$9.69

Rear drum support roller kit (roller, support)

This drum support roller kit is used for square-ported model clothes dryers. It has a metallic bearing in its center. This support roller is used to hold the drum in place in the cabinet while letting the drum rotate on the support rollers. If your dryer is noisy, will not tumble, or takes too long to dry you might need to replace the roller. The kit is a genuine OEM kit and it includes two drum support rollers, four tri rings, and one retaining washer. It is recommended that you replace both rollers at once. Please remember to disconnect the power to your appliance before starting your repair.

Easy Part #:

EAP347627

Availability:

In Stock

Price:

$15.68

Door catch kit (strike, door)

This door catch kit contains two door strikes and three door catches to service dryer doors that have one or two catches. Make sure to read the instructions to determine which one to use for your model. These parts keep the dryer door closed to allow the dryer to operate. If your door won't stay closed or will not start you may need to replace this part. This is a genuine OEM part.

Easy Part #:

EAP334230

Availability:

In Stock

Price:

$4.20

Idler pulley assembly

The idler pulley wheel provides the tension for a multi-ribbed belt and helps the belt to rotate the drum. The drum will not spin if the idler pulley fails to put the correct amount of tension on the belt. The wheel is white in color and is made of plastic. If the drum will not tumble, is noisy, or will not start, you may need to replace this part. This idler pulley is a genuine OEM part. Please remember to disconnect the power to your dryer before you start your repair.

Easy Part #:

EAP11743765

Availability:

In Stock

Price:

$14.03

Drive motor with pulley (motor assembly 60 hz.)

This drive motor operates the dryer by turning the drive belt which spins the drum and will fit most Whirlpool incorporated dryer brands before 1996. If the motor has shorted out, it will no longer turn the drum and will need to be replaced. The drive motor includes the pulley that is not available separately. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.

Easy Part #:

EAP334304

Availability:

In Stock

Price:

$85.25

Tri ring (ring, tri)

The tri ring is used to hold the drum support rollers or the idler pulley onto the shaft. If your dryer will not tumble or is noisy, you may need to replace the tri ring. This is a genuine OEM part and is sold individually.

Easy Part #:

EAP11755850

Availability:

In Stock

Price:

$6.48

Dryer lint filter and cover (lint screen)

Cover and filter as an assembly

Easy Part #:

EAP11726200

Availability:

In Stock

Price:

$38.21

Heating element connection wire kit (wire kit (for heater element wiring harness reppair))

This kit is used for electric clothes dryers, and it comes with a yellow wire nut.

Easy Part #:

EAP334206

Availability:

In Stock

Price:

$6.31

Lid switch (switch, door)

The door switch is a simple on/off mechanism that prohibits the dryer from operating when the door is open. The dryer cannot operate until the door switch signals that the door is closed. If your dryer will not start or the switch shorted out, your washer will not operate and the switch will need to be replaced. This switch is a genuine OEM part. Please remember to disconnect power to the dryer before starting the repair.

Easy Part #:

EAP11723153

Availability:

In Stock

Price:

$22.63

Screw, 8/18 x 3/8 (screw)

This screw is sold individually.

Easy Part #:

EAP11746840

Availability:

In Stock

Price:

$4.58

Dryer door switch actuator spring/lever (clip, door switch)

This black actuator spring with white rubber tip is used for both dryer doors and washer lids.

Easy Part #:

EAP11743767

Availability:

In Stock

Price:

$5.81

Cycling thermostat - limit 135/155 (thermostat 140 degree f. (60 degree c) 342812 (alt.))

Cycling themostats continually cycle the heating element off and on to maintain a constant inner temperature within the dryer. This particular cycling thermostat can be adjusted between 135 and 155 degrees Fahrenheit. The differential of this thermostat is 20 degrees, meaning that with this thermostat, the heating element will cycle back on once the internal temperature drops by 20 degrees.

Easy Part #:

EAP11743793

Availability:

In Stock

Price:

$30.26

Screw

Metallic screw that is less than an inch long. Does not include the plastic washer.

Easy Part #:

EAP11742721

Availability:

In Stock

Price:

$4.73

Lint trap housing seal (seal)

This seal comes with the adhesive backing.

Easy Part #:

EAP11741506

Availability:

In Stock

Price:

$6.13

Drum roller shaft - left side (shaft, l.H.)

Replace the shaft of your left side drum support roller with this part from Whirlpool/Kenmore. This replacement shaft is 2-7/8 inches long and comes with a washer and a nut. It is meant for use with many of Whirlpool/Kenmore's gas and electric clothes dryers that have been manufactured since 1965. Also known as Drum Roller Shaft.

Easy Part #:

EAP11753706

Availability:

In Stock

Price:

$25.06

1-15 of 114