10688419300 Kenmore Dryer Parts List

Single front panel cip (clip)

This part is the replacement single front panel clip for your dryer. It is made of metal and is approximately 2 inches long and ¾ inch wide. The front panel retainer clip is what holds the front panel on to the dryer. If the clip is damaged or missing, or if the front panel appears loose, you may need to replace the clip. This part is sold individually and is an authentic OEM part.

Cover screw (screw)

Sold individually.

Drum support roller shaft - right side (shaft, r.H.)

Replace the shaft of your right side drum support roller with this part. This replacement shaft is 3-3/16 inches long, but does not require a washer or a nut.

Door catch (catch, door)

This white female door catch is attached to the dryer door.

Push-to-start switch kit (switch, push to start)

This includes the switch, brackets and hardware.

Screw, 8-18 x 1/2 (screw, tapping)

This screw is sold individually.

Motor pulley (pulley, 60 hz.)

This part is the replacement motor pulley for your dryer. The motor pulley allows the dryer belt to run straight while the dryer is operating. If your motor pulley is damaged, your dryer may not tumble, and may not start altogether. A damaged motor pulley can also damage the dryer belt, and it may need to be replaced as well. Be sure to disconnect power from the dryer before you begin this repair. This motor pulley is a genuine OEM part sourced directly from the manufacturer.

Multi rib belt (belt, drive)

Specifications: Length 79-1/8 inch, width 1/4 inch, 4 ribs, Flat.

Door handle (white)

White in color.

Single hex head screw (screw)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Screw

This screw is sold individually.

Roller shaft washer (washer, support)

Bearing and seal kit (seal & bearing assembly)

This front bearing and seal kit comes with the adhesive.

Clamp-motor (clip, motor 343481 (alt.) 685411 (alt.))

This clamp is used to secure the drive motor.

Knob spring-clip (clip)

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.