10689485991 Kenmore Beverage Parts List

Ice cutting grid wire (wire, grid cutter)

The wire kit attaches to the cutter grid frame. The wire is used to cut the ice slab into cubes. There is approximately 10 feet of wire. Note: 2 kits are needed to replace both directions. This is a genuine OEM kit. It is recommended to disconnect power to the appliance before starting the repair.

Ice cutter grid complete assembly (grid assembly (complete))

This is an OEM part, sourced directly from the manufacturer. The cutter grid is located within the main unit of the ice maker and contains thin, heated wires that slice the ice into cubes that are then deposited in the ice bin. If the cutter grid is broken, ice can back up within the ice maker. This part is sold as a complete assembly and is used with freestanding ice makers.

Thermistor (thermostat, bin)

If your standalone ice maker is making too much ice, not enough ice, or none, you may need to replace the bin thermostat. This part will sense how much ice is in the bin and decide if it should produce more or stop the production of ice. You can test the thermostat for continuity with an ohm meter. This part is made of metal and plastic and is white in color. This is a genuine OEM part.

Condenser fan motor (motor, fan)

NOTE: As per the manufacture the part does not come threaded. A self tapping screw will need to be used to make threads.

Circulation pump with motor (pump, water (complete))

Used in freestanding ice-cube makers.

Water tube kit (tube, water fill)

The water tubing is made of plastic and goes between the water valve and the back of your refrigerator. The tubing is 72-inch in length, 1/4 inch in diameter, and comes with 2 inserts. This tube may be longer than the original tube and may need to be cut to fit your appliance. The water tube transports water to the ice and water dispensers. If there is no water going to the ice maker, your refrigerator is leaking, or if the ice and water dispensers are not dispensing properly, you may need to replace this tube kit. This part is an OEM part directly from the manufacturer. Please remember to shut off the water supply and to disconnect the power to your refrigerator before starting your repair.

Scoop

Compression nut (nut, compression)

This single 1/4-inch compression nut is used to connect the lines that supply water to the correct components, the water dispenser and the ice maker, with the plastic water line of the icemaker assembly. This is a genuine OEM part. Please remember to disconnect the power and water supply to the refrigerator before starting your repair.

Water inlet valve (valve, complete water)

This part releases water from the supply line when it's activated.

Screw (screw 10-32 x 11/16)

Sold individually.

Screw (screw 8-32 x 3/4)

Sold individually.

Drain fastener cap (cap, drain)

Single hex head screw (screw 8-18 x 1/2)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Ice maker water distributor tube (tube, plastic)

The water distributor tube distributes water from the reservoir to the evaporator plate.

Condenser fan blade - steel (blade, fan)

This fan blade circulates air over the condenser. It mounts onto the shaft of the condenser fan motor.