1069864820 Kenmore Beverage Parts List

Screw, 8/18 x 3/8 (screw, 8 x 3/8)

This screw is sold individually.

Ice cutting grid wire (wire, grid cutter)

The wire kit attaches to the cutter grid frame. The wire is used to cut the ice slab into cubes. There is approximately 10 feet of wire. Note: 2 kits are needed to replace both directions. This is a genuine OEM kit. It is recommended to disconnect power to the appliance before starting the repair.

Screw (screw #8 x 1/2)

Metallic screw that is less than an inch long. Does not include the plastic washer.

Scoop

Compression nut (nut and sleeve assembly)

This single 1/4-inch compression nut is used to connect the lines that supply water to the correct components, the water dispenser and the ice maker, with the plastic water line of the icemaker assembly. This is a genuine OEM part. Please remember to disconnect the power and water supply to the refrigerator before starting your repair.

Screw (screw, 10-12 x 1/2)

This screw is sold individually.

Single outlet water valve kit (valve, complete water)

This single outlet water valve is intended for use with some commercial ice machines, and not refrigerator icemakers. It comes with a mounting bracket, two screws, and a washer.

Ice maker water pump and motor (pump, water (complete))

This part helps circulate water through the evaporator to form ice that will be cut into cubes.

Plastic tubing inserts - 4 included (insert)

These inserts are used with 1/4 inch plastic tubing.

Control thermostat (thermostat, evaporator)

Also known as evaporator control thermostat - used for stand-alone ice makers.

Screw

This screw is sold individually.

Cycling thermostat (thermostat, bin control)

Used in stand-alone ice makers. The cycling thermostat controls the activation of the icemaker ejection cycle.

Terminal cover (cover, terminal)

Covers Relay/Overload on the Compressor

Ice grid cutter (grid assembly (complete))

Used on freestanding ice makers.

Filter drier tube (drier)

The filter drier tube with system access port, works in conjunction with your refrigerator by filtering the refrigerant that travels through the seal system of your refrigerator. This part measures approximately 10” long and is a genuine OEM part. Please make sure to disconnect the power before starting the repair. Please note it is recommended to have a service technician install the filter drier tube because it involves recharging and recovering refrigerant in the sealed refrigerant system.