106W14E5 Kenmore Refrigerator Parts List

Defrost timer (refrigerator defrost timer kit. This timer is designed for continuous or cumulative run defrost systems. Turn the dial on the timer clockwise to advan)

This 120 volt, 60Hz defrost timer acts like a clock, continually advances and alternates between activating the cooling cycle and the defrost heater. If the refrigerator is too warm, freezer section too warm or freezer not defrosting you might need to replace the defrost timer. This is a genuine OEM part. Disconnect the power to the refrigerator before starting the repair.

Screw (screw with plastic washer 8-18 x 1/2)

Metallic screw that is less than an inch long. Does not include the plastic washer.

Spray paint - 12 oz. - white (spray paint, white, 12 ounces)

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

Light socket kit

The bulb is sold separately.

Door hinge nylon washer (washer, door hinge)

Defrost thermostat (defrost thermostat with wires, l40-25)

This refrigerator defrost thermostat will cut out at 40 degrees Fahrenheit and kick back when the temperature drops to 25 degrees Fahrenheit.

Hinge washer (door hinge washer/spacer)

The hinge washer works in conjunction with the door hinge on the refrigerator door. This part is white in color and measures approximately 0.75” in diameter. If the refrigerator door is making noise opening and closing, you may need to replace this part. This is a genuine OEM part and is sold individually.

Inlet hose washer (gasket, water inlet hose)

The high-pressure inlet hose washer is black in color. It is one inch in diameter, made of rubber, and used with many washing machines, refrigerators, and dishwashers. The washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged and will need to be replaced. This is a genuine OEM part and is sold individually.

Speed nut

The speed nut works in conjunction with the condenser fan motor. The fan blade attaches to the condenser motor shaft and the speed nut secures the blade to the motor. Make sure the speed nut is properly attached and secured. If the part is damaged, worn, or will not tighten, you will need to replace it. This part measures 1/4-20 inch. Sold individually. Please remember to disconnect the power to the refrigerator before starting your repair.

Spray paint - superior black (spray paint, superior black, 12 ounces)

This is a 12oz aerosol can of black spray paint that will cover up nicks and scratches on your appliances. It is recommended to wear gloves to protect your hands while working with spray paint.

Transformer screw (screw)

This screw is sold individually.

Screw - #10 - 32x1/2 (screw, 10-24 x 1/2)

Sold Individually.

Rivet (rivet, plastic)

Bimetl-def (defrost thermostat with bracket, open at 70'f close at 12'f)

Silicone rubber adhesive - 2 oz (silicone rubber adhesive and sealant for felt seals, door gaskets and more. 2 ounces)

This 2oz high temperature silicone rubber adhesive is used to create a water tight seal for gaskets and felt seals. The working surface must be clean, dry and free from any type of oil or grease. This is a genuine OEM part. It is recommended to wear gloves to protect your hands while working with the adhesive.