1102071299 Kenmore Washer Parts List

Centerpost bearing and seal assembly (centerpost bearings and seals)

This assembly comes with one transmission stem seal, two center post bearings, and three agitator shaft seals.

Washer, spin tube thrust (washer)

Fits under the basket drive assembly.

Seal-shaft (seal shaft)

Transmission shaft seal.

Timer

The timer controls most of the operations of the washer: water level, tub filling and emptying, length of cycles, and cycle setting sequences.

Agitator cam bearing (bearing)

Inner tub filter plug kit (filter plug4)

Kit contains 4 plugs - replaces the lint filter that goes under spin basket. The filter under the spin basket is no longer required. Replaces round filter assembly.

Knob spring-clip (spring clip)

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.

Lid switch actuator assembly (actuator)

This part is used to activate the lid switch when the lid opens/closes.

Washer, agitator (washer)

Sold individually.

Upper agitator (top half of agitator assembly)

Hose clamp (clamp, hose)

The hose clamp helps secure the hose in place on the pump to avoid the pump or hose from leaking water onto your floor. If you notice your appliance leaking you may have a crack in the hose or the clamp is loose and will need to be replaced. This part is made of metal, measures approximately 2” in diameter and sold individually. This is a genuine OEM part.

Switch, main drive motor (motor switch)

Rear leveling foot (foot)

Sold Individually. Used to help stabilize the appliance on uneven surfaces.

Gearcase oil (gear case oil)

This gearcase oil comes in a 16 Oz bottle.

Nut-push-in (nut)

Sold individually.