1102371220 Kenmore Washer Parts List

Drain hose with clamp (hose, drain (4 ft.))

Used to drain water.

Spin tube bearing ("t" bearing, spin tube)

This spin tube T-Bearing is an inch long. Sold individually.

Screw, 8-18 x 1/2 (screw, 10-16 x 3/8 (5))

This screw is sold individually.

Leveling leg locking nut (nut, 3/8-16)

This nut is sold individually. Size: 3/8-16

Spacer (spacer, cabinet to top)

Used to put a space between the cabinet and the top of the washer.

Water level switch (switch, water level)

This part is located behind the control panel. It helps determine the level of water in the washer. As the water fills the hose, while tub is filling, it will push the air against a diaphragm inside the switch. More water that enters the tub, more pressure is applied against the switch.

Spring outer bracket (bracket, spring outer (2))

Sold individually.

Cabinet retaining clip (clip, top and cabinet and rear panel (2))

CLIP-TOP&CAB-R PNL

Inlet hose - 5 ft (hose, inlet (blue coupler))

This hose can handle hot or cold water and is five feet long.

Washer gear case cover seal (seal, gearcase cover)

This part prevents the agitator shaft from leaking oil onto the transmission.

Single motor grommet (grommet, motor (4))

Sold Individually.

Oil seal kit for gearcase input shaft (seal, thrust plug)

This two piece oil seal kit comes in two pieces and is used for the gearcase input shaft of your washer.

Screw (screw and washer, lid switch)

Sold individually.

Capacitor, motor start

This part gets the motor up to speed quickly before transferring power to the run capacitor.

Neutral drain kit (neutral assembly)