1104812791 Kenmore Washer Parts List

Touch-up paint - white (white touch-up paint)

This 18 ml bottle of white appliance touch-up paint is used to cover scratches or marks on your appliance. The white touch-up paint can be used on refrigerators, microwaves, ranges, clothes dryers, and freezers. This is a genuine OEM part and includes a brush applicator. Please remember to wear gloves to protect your hands when applying this paint.

Lid hinge mounting screw (screw, 6-32x.340 flat)

Sold individually. NOTE: The color on the screw may not be the same as the image, but will still function the same.

Hose clamp

This hose clamp expands from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag washing machines to secure the end of the drain hose to the pump drain port. Please make sure to disconnect the power to your washer before you start your repair. This hose clamp is a genuine OEM part and is sold individually.

Spray paint - 12 oz. - white (spray paint, white, 12 ounces)

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

Hose clamp

This single hose clamp is used to hold the water hose in place on the pump, to avoid the hose or pump from leaking water. If you notice your washer leaking you may need to replace the clamp. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

Lid strike (washing machine lid strike)

This part is used to activate the lid switch when the lid opens/closes.

Drain hose with clamp (washing machine drain hose (48") with clamp)

Used to drain water.

Lid hinge pad (pad, lid hinge)

Sold individually.

Inlet hose - 5 ft (5-foot-long rubber fill hose for washing machines. Used for hot or cold water.)

This hose can handle hot or cold water and is five feet long.

Snubber strap (tub support snubber strap)

Sold individually.

Knob spring-clip (spring clip, knob)

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.

Hose clamp

The hose clamp helps secure the hose in place on the pump to avoid the pump or hose from leaking water onto your floor. If you notice your appliance leaking you may have a crack in the hose or the clamp is loose and will need to be replaced. This part is made of metal, measures approximately 2” in diameter and sold individually. This is a genuine OEM part.

Hose clamp (hose clamp, spring tension)

This clamp helps to prevent leaking by holding the end of water hose in place.

Touch-up paint - almond (almond touch-up paint)

Affresh washing machine cleaner - 3 pack (affresh cleaner)

This front load washer cleaner removes odor-causing residue. Use it once a month and it will keep your machine fresh and clean. Package comes with 3 tablets.