1106007299 Kenmore Dryer Parts List

Drive motor with threaded shaft - 120v 60hz (dryer drive motor. The drive motor drives the rotation of the dryer's drum. If the drive motor is defective, the dryer won't spin..)

The blower shaft is 1-5/8 inches long, while the drive shaft is 1-1/4 inches long.

Spray paint - 12 oz. - white (spray)

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

Drum support roller shaft - right hand threads (shaft, r.H. Thread)

This shaft is for the front with right hand thread. Sold individually.

Motor pulley (pulley 60 hz.)

This part is the replacement motor pulley for your dryer. The motor pulley allows the dryer belt to run straight while the dryer is operating. If your motor pulley is damaged, your dryer may not tumble, and may not start altogether. A damaged motor pulley can also damage the dryer belt, and it may need to be replaced as well. Be sure to disconnect power from the dryer before you begin this repair. This motor pulley is a genuine OEM part sourced directly from the manufacturer.

Single access panel clip (clip (2))

Sold individually.

Dryer screw (screw, 11-16 x 3/4)

11-16 x 3/4 Sold individually.

Leveling leg locking nut (nut, 3/8 x 16 (r.H.))

This nut is sold individually. Size: 3/8-16

Washer (washer, support)

This support washer is located on the drum roller support shaft and it helps prevent the drum roller and pulley from rubbing against the bracket they are attached to. If your dryer is making noises, it may be the support washer becoming loose on the support shaft. The manufacturer suggests replacing the support washers at the same time as the rollers. This is a genuine OEM part. Please make sure you disconnect the power to the dryer before starting your repair.

Terminal block - block only (terminal block)

This part is an electrical connector where you can attach wires. This part does NOT included the wires, screws, and nuts. Must be order separately

Blower housing seal (seal)

This part seals between the blower housing and the blower housing cover.

Spring (spring, idler)

Single hex head screw (screw 1/4" hex head, 10-12 x 1/2)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Door handle (handle, door)

White in color.

Seal, outlet housing

Screw (screw, 10-16 x 1/2)

This screw is sold individually.