1107080299 Kenmore Dryer Parts List

Drum support roller shaft - right side (shaft)

Replace the shaft of your right side drum support roller with this part. This replacement shaft is 3-3/16 inches long, but does not require a washer or a nut.

Door catch (door latch kit)

This white female door catch is attached to the dryer door.

Motor pulley - 60 hz. (motor pulley)

Sold individually.

Spray paint - 12 oz. - white (spray)

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

Internal-bias thermostat (cycling thermostat, with internal-bias heater l155-25f)

This thermostat has an internal heater L155-25F. This thermostat controls the internal drying temperature.

Timer (control timer)

This dryer timer is used to control the unit's cycles by regulating the length of time that power is directed to each setting.

Front top lock (lock)

This part is used to secure the top panel to the cabinet. Sold individually.

Seal-door (door seal)

Push-to-start switch (pts switch)

This part is used to start the dryer once you have selected a setting on the timer.

Dryer screw (screw)

11-16 x 3/4 Sold individually.

Leveling leg locking nut (nut)

This nut is sold individually. Size: 3/8-16

Temperature selector switch (switch)

This switch allows you to change the cycle settings on your dryer.

Single hex head screw (screw 1/4" hex head, 10-12 x 1/2)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Support roller clip (clip)

Sold Individually.

Door handle (handle)

White in color.