1107099299 Kenmore Dryer Parts List

Multi rib belt (drive belt)

This dryer drum belt from Whirlpool/Kenmore has five ridges. It is used for many of Whirlpool's brands of clothes dryers. This flat belt is 1/4 of an inch wide.

Moisture sensor (dryer moisture sensor bar. This moisture sensor monitors the clothing’s moisture level and sends a signal to the control board when the clothes are dr)

This is the moisture sensor for your dryer. It helps detect the amount of moisture in your clothes during the dryer cycle. If you notice your clothes are still wet after an automatic dryer cycle is done, you may need to replace the sensor. You will find the moisture sensor behind the lint screen. Be sure to disconnect the power source from the dryer before you begin this repair. Note: Some model's require two sensors, please order quantity needed. Sensor only, harness is not included. This part is sold individually.

Screw, 8/18 x 3/8 (screw 8pk)

This screw is sold individually.

Dryer drum seal with adhesive (seal)

This part seals the drum to prevents air from escaping. This includes silicone rubber adhesive.

Touch-up paint - white (tuchup)

This 18 ml bottle of white appliance touch-up paint is used to cover scratches or marks on your appliance. The white touch-up paint can be used on refrigerators, microwaves, ranges, clothes dryers, and freezers. This is a genuine OEM part and includes a brush applicator. Please remember to wear gloves to protect your hands when applying this paint.

Thermal cut-off fuse kit (high-limit thermostat)

Dryer door switch actuator spring/lever (switch actuator)

This black actuator spring with white rubber tip is used for both dryer doors and washer lids.

Screw - 10-16 x 1 (screw)

This screw is sold individually.

Liquid propane conversion kit (dryer lp (liquid propane) conversion kit. From natural gas to lp.)

This part converts your appliance from Natural Gas to Liquid Propane.

Push-to-start switch - 2 terminal (push-to-start switch)

This part is used to start the dryer once you have selected a setting on the timer.

Drum support shaft - rear shaft with right hand threads (shaft)

Shaft for dryer drum support roller. Rear shaft with left hand threads. Part is updated so nuts may need to be replaced as well on older dryers.

Screw

Metallic screw that is less than an inch long. Does not include the plastic washer.

Blower wheel

The blower wheel pulls air over the heat source, through the clothes drum, and past the thermostats, then pushes it out the exhaust duct. The blower wheel, which is usually plastic, may wear out over time. But if it's noisy, it may simply be clogged with lint. Clean the blower and test to see if the dryer is still noisy. If it is, you probably need to replace it.

Cover screw (screw)

Sold individually.

Single access panel spring retainer/clip (clip, toe panel lock)

Sold Individually.