11076862692 Kenmore Dryer Parts List

Touch-up paint - white (white touch-up paint)

This 18 ml bottle of white appliance touch-up paint is used to cover scratches or marks on your appliance. The white touch-up paint can be used on refrigerators, microwaves, ranges, clothes dryers, and freezers. This is a genuine OEM part and includes a brush applicator. Please remember to wear gloves to protect your hands when applying this paint.

Thermal cut-off fuse kit (high-limit thermostat. If the dryer overheats, the high-limit thermostat cuts off power to the dryer. If the dryer won't heat, the high-limit thermost)

Lint trap housing seal (dryer foam seal with adhesive backing. This seals goes between the lint chute and the bulkhead.)

This seal comes with the adhesive backing.

Two-piece split ring bearing (ring bearing kit, front of dryer drum)

This is a replacement bearing ring kit for your dryer. The bearing rings are found on the top and bottom lips of the dryer drum. If your dryer is unusually noisy, or the drum will not turn during operation, or if there are marks left on your clothes after a cycle, you may need to replace the bearing ring kit. The kit comes with 2 bearings, one for the top and one for the bottom of the dryer drum. Remove the front panel of your dryer to access the dryer drum for this repair. At this point you can use a pair of needle nose pliers to release the old bearing rings from the drum. Snap the new bearing rings on, and reassemble the dryer to complete your repair.

Liquid propane conversion kit (dryer lp (liquid propane) conversion kit. From natural gas to lp.)

This part converts your appliance from Natural Gas to Liquid Propane.

Push-to-start switch - 2 terminal (dryer push-to-start switch, 2-terminal. If this switch is defective, the dryer will not start. To determine if the switch is defective, use a multimet)

This part is used to start the dryer once you have selected a setting on the timer.

Drum roller shaft - left side (shaft for drum support roller, left side)

Replace the shaft of your left side drum support roller with this part from Whirlpool/Kenmore. This replacement shaft is 2-7/8 inches long. It is meant for use with many of Whirlpool/Kenmore's gas and electric clothes dryers that have been manufactured since 1965. Also known as Drum Roller Shaft.

Seal (dryer blower housing foam seal with adhesive backing.)

This seal comes with the adhesive backing.

Seal and bearing (front panel felt seal. No glue required the seal streches to fit.)

This front panel seal kit doesn't include the plastic retainers, reuse the old retainers. No glue is needed, the seal stretches to fit.

Single front panel cip (dryer front panel retainer clip. 1 clip per pack.)

This part is the replacement single front panel clip for your dryer. It is made of metal and is approximately 2 inches long and ¾ inch wide. The front panel retainer clip is what holds the front panel on to the dryer. If the clip is damaged or missing, or if the front panel appears loose, you may need to replace the clip. This part is sold individually and is an authentic OEM part.

Cover screw (screw)

Sold individually.

Drum support roller shaft - right side (shaft for drum support roller, right side)

Replace the shaft of your right side drum support roller with this part. This replacement shaft is 3-3/16 inches long, but does not require a washer or a nut.

Motor pulley - 60 hz. (motor pulley, 60 hertz)

Sold individually.

Spray paint - 12 oz. - white (spray paint, white, 12 ounces)

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

Timer (dryer timer. The timer controls all of the functions of the dryer. If the timer is defective, the dryer may not start or may not advance through the d)

This dryer timer is used to control the unit's cycles by regulating the length of time that power is directed to each setting.