110828918110 Kenmore Washer Parts List

Water inlet hose washer (washer for fill hose)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Screw, console (console screw)

Sold individually.

Centerpost bearing and seal assembly (centerpost bearing and seal kit for direct drive washer. The brake removal tool is needed for easy removal of your original bearing. Please see relate)

This assembly comes with one transmission stem seal, two center post bearings, and three agitator shaft seals.

Washer, spin tube thrust

Fits under the basket drive assembly.

Inner tub filter plug kit (filter plug kit for inner tub, replaces round filter assembly)

Kit contains 4 plugs - replaces the lint filter that goes under spin basket. The filter under the spin basket is no longer required. Replaces round filter assembly.

Knob spring-clip (spring clip, knob)

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.

Lid switch actuator assembly (lid switch actuator kit)

This part is used to activate the lid switch when the lid opens/closes.

Upper agitator (upper agitator assembly)

Hose clamp

The hose clamp helps secure the hose in place on the pump to avoid the pump or hose from leaking water onto your floor. If you notice your appliance leaking you may have a crack in the hose or the clamp is loose and will need to be replaced. This part is made of metal, measures approximately 2” in diameter and sold individually. This is a genuine OEM part.

Rear leveling foot (self adjusting rear leveling leg with pin)

Sold Individually. Used to help stabilize the appliance on uneven surfaces.

Gearcase oil (gearcase (transmission) oil for Whirlpool built direct drive top load washers. 16 ounces)

This gearcase oil comes in a 16 Oz bottle.

Nut-push-in (stop, push-in)

Sold individually.

Control panel hinge

Sold individually.

Hose clamp (hose clamp, spring tension)

This clamp helps to prevent leaking by holding the end of water hose in place.

Lid switch actuator

This is part of the lid switch actuator mechanism and activates the lid switch, when the lid is closed, to start the wash cycle and when the lid is open, it stops the cycle.