110C85088400 Kenmore Dryer Parts List

Dryer screw (screw, baffle mounting)

11-16 x 3/4 Sold individually.

Leveling leg locking nut (locking nut for leveling leg)

This nut is sold individually. Size: 3/8-16

Washer (support washer)

This support washer is located on the drum roller support shaft and it helps prevent the drum roller and pulley from rubbing against the bracket they are attached to. If your dryer is making noises, it may be the support washer becoming loose on the support shaft. The manufacturer suggests replacing the support washers at the same time as the rollers. This is a genuine OEM part. Please make sure you disconnect the power to the dryer before starting your repair.

Blower housing seal (seal, blower cover plate)

This part seals between the blower housing and the blower housing cover.

Spring (spring for idler pulley arm in dryer)

Handle (white)

White in color. Handle only.

Single hex head screw (screw 1/4" hex head, 10-12 x 1/2)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Seal, outlet housing (outlet housing seal with adhesive strip)

Terminal block screw kit (screw and nut kit, electric dryer cord connector.)

This kit includes 3 screws and 3 nuts.

Stacking kit (stacking kit to stack the new duet washer and dryer vertically, dryer over washer.)

This kit comes with 2 adhesive pads, 2 brackets and 4 screws. This is for stacking the appliances vertically - dryer over washer.

Clamp-motor (motor retaining clamp)

This clamp is used to secure the drive motor.

Side and bottom vent kit (side or bottom venting kit)

This kit is used for the bottom and side exhaust. The kit includes both the straight and elbow vent.

Door switch with wire (dryer door switch & harness assembly)

This part is what tells the dryer to stop running when the door is open.

Moisture sensor wire harness (harness, sensor)

Lens (light lens cover)

This parts covers the bulb inside the drum.