11015862400 Kenmore Washer Parts List

Hose clamp (clamp, hose)

The hose clamp helps secure the hose in place on the pump to avoid the pump or hose from leaking water onto your floor. If you notice your appliance leaking you may have a crack in the hose or the clamp is loose and will need to be replaced. This part is made of metal, measures approximately 2” in diameter and sold individually. This is a genuine OEM part.

Rear leveling foot (foot, rear (2))

Sold Individually. Used to help stabilize the appliance on uneven surfaces.

Nut-push-in (nut, push-in)

Sold individually.

Shaft, agitator (complete) (gear, agitate (includes 15 and 29))

This kit is used for direct drive washing machines and is found inside the gearcase.

Hose clamp (clamp, hose)

This clamp helps to prevent leaking by holding the end of water hose in place.

Timer dial - white (dial and guard, timer (white))

Cord-power (cord, power (includes item 8))

Ring-wire (ring, retaining)

This is part of the Basket Drive and found under the Brake Lining parts.

Washer outer tub (tub)

This part holds the water during the wash cycle and houses the spin basket.

Water pressure hose - cut-to-fit (hose, pressure switch)

This is the hose that tells your appliance if your tub is at the desired water level.

Ring, spin tube support

Used with clutch.

Bracket, spring outer (l.F.)

Brake shoe assembly (shoe, brake)

This assembly comes with two brake shoes.

Motor start capacitor (capacitor, motor start)

This capacitor gets the motor up to speed before transferring power to the run capacitor.

Clip

Wiring harness clip.