11016602691 Kenmore Washer Parts List

Inlet hose - 5 ft (inlet hose)

This hose can handle hot or cold water and is five feet long.

Single motor grommet (motor grommet)

Sold Individually.

Screw (lid switch screw and washer)

Sold individually.

Capacitor, motor start (capacitor)

This part gets the motor up to speed quickly before transferring power to the run capacitor.

Screw

This screw is sold individually.

Water inlet hose washer (washer)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Screw, console

Sold individually.

Centerpost bearing and seal assembly (centerpost bearings and seals)

This assembly comes with one transmission stem seal, two center post bearings, and three agitator shaft seals.

Washer, spin tube thrust (washer)

Fits under the basket drive assembly.

Agitator cam bearing (bearing)

Inner tub filter plug kit (filter plug4)

Kit contains 4 plugs - replaces the lint filter that goes under spin basket. The filter under the spin basket is no longer required. Replaces round filter assembly.

Knob spring-clip (spring clip)

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.

Lid switch actuator assembly (actuator)

This part is used to activate the lid switch when the lid opens/closes.

Washer, agitator (washer)

Sold individually.

Switch, main drive motor (motor switch)