11016812501 Kenmore Washer Parts List

Spring outer bracket (bracket spring)

Sold individually.

Inlet hose - 5 ft (inlet hose)

This hose can handle hot or cold water and is five feet long.

Cabinet retaining clip (clip)

CLIP-TOP&CAB-R PNL

Console clip

Sold individually.

Washer gear case cover seal (gear case cover seal)

This part prevents the agitator shaft from leaking oil onto the transmission.

Single motor grommet (motor grommet)

Sold Individually.

Oil seal kit for gearcase input shaft (seal)

This two piece oil seal kit comes in two pieces and is used for the gearcase input shaft of your washer.

Water level switch

This part is located behind the control panel. It helps determine the level of water in the washer. As the water fills the hose, while tub is filling, it will push the air against a diaphragm inside the switch. More water that enters the tub, more pressure is applied against the switch.

Capacitor, motor start (capacitor)

This part gets the motor up to speed quickly before transferring power to the run capacitor.

Neutral drain kit (neutrl pak)

Water inlet hose washer (washer)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Centerpost bearing and seal assembly (centerpost bearings and seals)

This assembly comes with one transmission stem seal, two center post bearings, and three agitator shaft seals.

Washer, spin tube thrust (washer)

Fits under the basket drive assembly.

Agitator cam bearing (bearing)

Washer, agitator (washer)

Sold individually.