Parts for Kenmore Models 11027172600

Agitator directional cogs (agitator dogs)

These agitator directional cogs are commonly referred to as dog ears. They come four in a package and are usually used with direct drive washing machines. When the teeth on the outer edge are worn down the cogs will not engage with the upper agitator, causing it not to agitate properly. It is recommended to replace all four at the same time. These agitator directional cogs are ?-inch high and 1-inchlong and they are a genuine OEM part.

Easy Part #:: EAP388034

Availability:: In Stock

Price:: $4.34

Direct drive water pump (complete pump)

This pump is intended for use with washing machines that do not have belts. This drain pump has two ports for water to pass through: a large one, and a smaller one. This part is used to remove water from the tub during the drain cycle. If your washer is leaking, not draining, pumps but will not spin or fills and drains at the same time you may need to replace the pump. The pump is located on the motor and is attached by two clips. This part is white in color, made from plastic and is a genuine OEM part. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair.

Easy Part #:: EAP11741239

Availability:: In Stock

Price:: $39.65

Suspension spring

This suspension spring is used to support and balance the outer tub of your washer. If the spring is broken it will cause the washer to be off balance and noisy. Check your model to see how many springs are required for your model. The spring is sold individually.

Easy Part #:: EAP11743345

Availability:: In Stock

Price:: $6.43

Agitator bolt (screw)

This kit contains one screw with rubber gasket and threaded sealant. The screw head is 7/16".

Easy Part #:: EAP11741866

Availability:: In Stock

Price:: $7.02

Tub spring (spring)

This suspension spring is used to support and balance the outer tub of your washer. If the spring is broken it will cause the washer to be noisy and off balance during the spin cycle. Please check your model to see how many springs are required for your model. The spring is sold individually. This is a genuine OEM part. Please make sure you disconnect the power to the washer before starting your repair.

Easy Part #:: EAP11751118

Availability:: In Stock

Price:: $4.38

Centerpost gasket (gasket)

Also known as Main Outer Tub Seal. This part helps to prevent leaking from the bottom of the tub.

Easy Part #:: EAP11723081

Availability:: In Stock

Price:: $5.62

Thrust spacer (washer)

This white thrust spacer is made of plastic and is also commonly referred to as a retainer ring. It is approximately 2 1/2-inch in diameter. The thrust spacer is used in the agitator assembly between the agitator and the auger. The thrust spacer supports the agitator auger as it moves. It is used in many direct drive washer machine models. If your washer will not agitate or is noisy, you may need to replace the thrust spacer. Please be sure to disconnect the power to your washer before starting your repair. You may need agitator grease for the repair. This is a genuine OEM part.

Easy Part #:: EAP334562

Availability:: In Stock

Price:: $4.42

Lid switch

This is a replacement lid switch for your washer. The pin on the lid pushes on the lever of the lid switch to tell the machine that the lid is closed.

Easy Part #:: EAP11722098

Availability:: In Stock

Price:: $37.79

Gearcase (complete transmission assembly)

This is used in your direct drive washer that has a neutral drain.

Easy Part #:: EAP341974

Availability:: In Stock

Price:: $179.29

Foot, front - single (foot, leveling)

The adjustable leveling leg is used to support and keep your washer level. It also allows you to adjust the height of your washer. If your washer is shaking, vibrating, or moving during operation you may need to replace this part. This part has a rubber foot, almost 3” long and is made of metal and rubber. This is a genuine OEM part and is sold individually.

Easy Part #:: EAP11747965

Availability:: In Stock

Price:: $4.38

Touch-up paint - white (tuchup)

This 18 ml bottle of white appliance touch-up paint is used to cover scratches or marks on your appliance. The white touch-up paint can be used on refrigerators, microwaves, ranges, clothes dryers, and freezers. This is a genuine OEM part and includes a brush applicator. Please remember to wear gloves to protect your hands when applying this paint.

Easy Part #:: EAP385132

Availability:: In Stock

Price:: $6.96

Lid hinge mounting screw

Sold individually. NOTE: The color on the screw may not be the same as the image, but will still function the same.

Easy Part #:: EAP11748588

Availability:: In Stock

Price:: $7.15

Drain hose (hose)

It connects from the pump to the back panel. The clamp is not included.

Easy Part #:: EAP11753688

Availability:: In Stock

Price:: $25.98

Hose clamp (clamp)

This hose clamp expands from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag washing machines to secure the end of the drain hose to the pump drain port. Please make sure to disconnect the power to your washer before you start your repair. This hose clamp is a genuine OEM part and is sold individually.