110279121 Kenmore Dryer Parts List

Igniter kit (ignitor)

This silicon carbide igniter with ceramic holder kit includes the 3-inch flat igniter, mounting bracket, 4-inch wire leads, and the plug. It can replace both round and flat igniters. This kit is used for many gas clothes dryers. This part ignites the gas within the dryer to heat the dryer during the cycle, so if your dryer takes too long to dry, has no heat or not enough heat, you may need to replace the igniter. Be sure to disconnect the power source from your dryer before you do this repair. The igniter is very fragile and should be handled with care.

Screw (screw, 10-16 x 1/2)

This screw is sold individually.

Natural gas orifice for dryer gas valve (type 1)

Screw (screw, 8-32 x 3/8)

This screw is sold individually.

Orifice, burner (type 4 (propa (type 4, propane)

Sold individually.

Orifice, burner (type 4 (butan (type 4, butane)

Dryer gas valve limiter (assembly, shut-off valve and union)

This gas valve limiter is for dryers. Gas valve limiter opens to release excess pressure from the gas valve if the gas supply pressure exceeds the normal rating. Unplug the dryer and shut off the gas supply before installing this part. Wear work gloves to protect your hands.

Pipe (pipe, tail)

Nut (nut, compression)

Pilot armature assem (assembly, coil, 50 hz)

Coil-valve (assembly, coil, assist)

Coil-valve (assembly, coil, main)

Coil-valve (assembly, coil, hold)

Spring, regulator

Terminal connector (block, connector)