1103387617 Kenmore Dryer Parts List

M series new style coil kit (coil, 60 hz. (2 terminal) (main))

This gas dryer ignition coil set comes with two ignition coils: one three-terminal boost/hold coil, and one two-terminal secondary coil. If there is no heat or your drying time is getting longer, the coils may be bad and will need to be replaced. Once the coils go bad they do not hold the gas valve open properly. Usually only one of them burns out but you should replace them as a set. Both must be operational for the gas valve to open. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.

Igniter kit (ignitor 686590 (alt))

This silicon carbide igniter with ceramic holder kit includes the 3-inch flat igniter, mounting bracket, 4-inch wire leads, and the plug. It can replace both round and flat igniters. This kit is used for many gas clothes dryers. This part ignites the gas within the dryer to heat the dryer during the cycle, so if your dryer takes too long to dry, has no heat or not enough heat, you may need to replace the igniter. Be sure to disconnect the power source from your dryer before you do this repair. The igniter is very fragile and should be handled with care.

Screw (screw, 10-16 x 1/2)

This screw is sold individually.

Natural gas orifice for dryer gas valve (type 1)

Natural gas limiter (leak, limiter)

Burner tube (tube, burner)

Includes hood.

Screw (screw, 8-18 x 3/8 (3))

Gas valve kit (valve, gas 60 hz. (complete))

This gas valve kit comes with the wiring harness.

Orifice, burner (type 4 (propa (type 4 (propane))

Sold individually.

Spring, regulator

Screw, regulator adjustment

Orifice, burner (type 4 (butan (type 4 (butane))

Wiring harness (harness, wiring (complete))

Bracket, ignitor

Screw (screw, 8-32 x 1/2 (2))