11045862400 Kenmore Washer Parts List

Washer door bellow (bellow)

Drain pump kit (pump (complete))

This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time. This part is used on front load models.

Washer baffle (baffle, tub)

This part moves the clothes around inside your dryer/washer and helps to direct the flow of hot air during the drying cycle. Sold individually.

Door lock latch (lock, door)

This part is used on front load washers and includes the interlock switch assembly.

Shock absorber

Shock absorbers help keep the washer from vigorous shaking during its cycles. Sold individually.

Screw, 8/18 x 3/8 (screw)

This screw is sold individually.

Water inlet valve (valve, inlet)

Used with some front load washers. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed.

Screw

Metallic screw that is less than an inch long. Does not include the plastic washer.

Bellow to outer tub clamp (clamp, bellow (rear))

Used to help hold your bellow in place on your washer.

Flowmeter

This part continually measures the amount of water entering the tub. It will make adjustments if too much or too little water is present.

Drive belt (belt)

This drive belt is made to slip on the motor pulley to bring the basket up to the speed required and this makes the belt get wear and tear. NOTE: Per Manufacture, belt measures 48.22" long uninstalled and the belt will stretch To 51.53" when installed.

Door hook/strike (hook, door)

Attaches to door lock mechanism.

Leveling foot & nut (foot assembly)

Sold individually.

Bellow clamp (clamp, bellow (front))

This is the replacement bellow clamp for your washer. It approximately 16 inches in diameter and is sold individually. The bellow clamp goes around the bellow in your washer and holds it in place on the washer frame. The main reason you would want to replace the bellow clamp is if it is rusted or damaged, and it is not holding the bellow into place. To remove the bellow clamp, simply use a screwdriver to pop the bellow clamp out of the groove it rests in. Place the new clamp back into the bellow groove until it snaps into place. This is an OEM part from the manufacturer.

Detergent dispenser drawer (drawer, detergent)

This part is the replacement detergent dispenser drawer for your washer. It is made of white plastic and is approximately 11 inches long, 6 inches wide, and 5 inches deep. The detergent dispenser is filled with detergent, which it dispenses during the wash cycle. If a lot of detergent remains in the dispenser after the wash cycle, your clothes aren’t getting clean, or you notice a crack or a break in the dispenser itself, it may need to be replaced. This is an OEM part sourced directly from the manufacturer, and is sold individually.