11046747802 Kenmore Washer Parts List

Washer door bellow (bellow)

Drain pump kit (complete drain motor and motor assembly)

This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time. This part is used on front load models.

Washing machine door hinge (hinge)

Shock absorber

Sold individually. These shock absorbers keep the washer from vigorous shaking during its cycles. This shock absorber is for washers. Shock absorber absorbs the vibrations and movements of the outer washer tub. Unplug the washer before installing this part. Wear work gloves to protect your hands.

Screw

Metallic screw that is less than an inch long. Does not include the plastic washer.

Bellow to outer tub clamp (clamp)

Used to help hold your bellow in place on your washer.

Flowmeter

This part continually measures the amount of water entering the tub. It will make adjustments if too much or too little water is present.

Drive belt (belt)

This drive belt is made to slip on the motor pulley to bring the basket up to the speed required and this makes the belt get wear and tear. NOTE: Per Manufacture, belt measures 48.22" long uninstalled and the belt will stretch To 51.53" when installed.

Bellow clamp (clamp)

This is the replacement bellow clamp for your washer. It approximately 16 inches in diameter and is sold individually. The bellow clamp goes around the bellow in your washer and holds it in place on the washer frame. The main reason you would want to replace the bellow clamp is if it is rusted or damaged, and it is not holding the bellow into place. To remove the bellow clamp, simply use a screwdriver to pop the bellow clamp out of the groove it rests in. Place the new clamp back into the bellow groove until it snaps into place. This is an OEM part from the manufacturer.

Hose clamp (clamp, hose)

This single hose clamp is used to hold the water hose in place on the pump, to avoid the hose or pump from leaking water. If you notice your washer leaking you may need to replace the clamp. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

Pump hose (hose)

This hose attaches to water pump assembly. NOTE: As per the manufacture if the washer has an Eco Ball, it's no longer needed when the new hose is installed.

Drain hose

This hose goes from the drain pump to the back of the washer.

Basket, complete os (basket)

NOTE: The original nut might not work. Must order new nut separately. Part # is PS2372970.

Door lock/latch (latch)

Drum drive pulley (pulley)

This drive pulley attaches to the back of the washers drum.