Hello!

You're visiting the Easy Appliance Parts site in U.S.

Would you like to shop on the Canadian site?

Stay on this site
Go to Canadian site

11047511702 Kenmore Washer Parts List

1-15 of 111

Washer drain pump (water pump)

This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period. It has two ports for water to pass through: a large one, and a smaller one. If your washer will not drain, is noisy, leaking, or pumps but will not spin you may need to replace the pump. This is a genuine OEM part. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair. This pump also comes with a removable filter.

Easy Part #:

EAP11757304

Availability:

In Stock - Ships Today

Price:

$96.27

Front load washer bellow - gray (bellow)

Also known as a door boot seal.This part is used to keep the clothes inside the tub during the wash cycle. The folds in the bellow allow the tub to move separately from the door during the spin cycle.

Easy Part #:

EAP11748353

Availability:

In Stock - Ships Today

Price:

$92.12

Foot, front - single (foot, leveling)

The adjustable leveling leg is used to support and keep your washer level. It also allows you to adjust the height of your washer. If your washer is shaking, vibrating, or moving during operation you may need to replace this part. This part has a rubber foot, almost 3” long and is made of metal and rubber. This is a genuine OEM part and is sold individually.

Easy Part #:

EAP11747965

Availability:

In Stock - Ships Today

Price:

$4.38

Touch-up paint - white (tuchup)

This 18 ml bottle of white appliance touch-up paint is used to cover scratches or marks on your appliance. The white touch-up paint can be used on refrigerators, microwaves, ranges, clothes dryers, and freezers. This is a genuine OEM part and includes a brush applicator. Please remember to wear gloves to protect your hands when applying this paint.

Easy Part #:

EAP385132

Availability:

In Stock - Ships Today

Price:

$6.96

Hose clamp (clamp)

This hose clamp expands from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag washing machines to secure the end of the drain hose to the pump drain port. Please make sure to disconnect the power to your washer before you start your repair. This hose clamp is a genuine OEM part and is sold individually.

Easy Part #:

EAP11743008

Availability:

In Stock - Ships Today

Price:

$6.49

Water inlet valve (valve)

This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature or amount of water needed.

Easy Part #:

EAP11746288

Availability:

In Stock - Ships Today

Price:

$60.83

Door lock latch (latch)

This part ensures that your door stays locked while the machine is running.

Easy Part #:

EAP11751211

Availability:

In Stock - Ships Today

Price:

$108.95

Spray paint - 12 oz. - white (spray)

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

Easy Part #:

EAP347819

Availability:

In Stock - Ships Today

Price:

$13.12

Washer dispenser hose (hose)

This dispenser hose is for washers and carries the contents of the dispenser drawer to the washer tub.

Easy Part #:

EAP12723930

Availability:

In Stock - Ships Today

Price:

$23.29

Hose

This is a replacement tub-to-pump hose for your washer. This hose runs from the bottom of the tub to the water pump, and is used to transport water. The hose can develop a hole, and when this happens you will notice water leaking onto the floor. The tub-to-pump hose is found below the washer tub. To disconnect the hose, you will need to release the clamps that hold it in place with a pair of pliers. When you replace the tub hose, you will need to transfer the ball, air chamber, and clamps from the old pump to the new one. To do this, you will need a set of wire cutters and a new zip tie to replace the one you will need to cut.

Easy Part #:

EAP12723931

Availability:

In Stock - Ships Today

Price:

$22.88

Drive belt

This part is the replacement drive belt for your washer. It is made of black rubber and is approximately ½ an inch wide and 48 inches long. It has 6 grooves and is sold individually. The drive belt is found between the motor pulley and the drive pulley, and it connects the motor to the drive system. When the belt is running, it allows the basket or tub to spin. If the belt is stretched, worn, or broken, the tub will not turn. A warped belt can also cause the washer to be noisy while operating. This part is an authentic OEM part sourced directly from the manufacturer.

Easy Part #:

EAP11746258

Availability:

In Stock - Ships Today

Price:

$41.03

Bellow to tub clamp (clamp)

This is the replacement bellow clamp for your washer. It is approximately 18 inches in diameter and is sold individually. The bellow clamp goes around the bellow in your washer and holds it in place on the washer frame. The main reason you would want to replace the bellow clamp is if it is rusted or damaged, and it is not holding the bellow in place. To remove the bellow clamp, simply use a screwdriver to pop the bellow clamp out of the groove it rests in. Place the new clamp back into the bellow groove until it snaps into place. This is an OEM part from the manufacturer.

Easy Part #:

EAP11746259

Availability:

In Stock - Ships Today

Price:

$23.22

Easy Part #:

EAP11742705

Availability:

In Stock - Ships Today

Price:

$6.02

Bellow to front panel clamp (clamp)

The door boot spring clamp or outer bellow clamp on your washer is designed to keep the door boot in place. It is circular in shape, and you will find it wrapped around the bellow. To remove the old clamp, simply open the washer door, and use a screwdriver to pop it out. This is an OEM part sourced directly from the manufacturer.

Easy Part #:

EAP11773093

Availability:

In Stock - Ships Today

Price:

$19.90

Leveling leg locking nut (nut)

This nut is sold individually. Size: 3/8-16

Easy Part #:

EAP11741219

Availability:

In Stock - Ships Today

Price:

$5.73

1-15 of 111