11057624 Kenmore Washer Parts List

Hose clamp (clamp, hose)

This hose clamp expands from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag washing machines to secure the end of the drain hose to the pump drain port. Please make sure to disconnect the power to your washer before you start your repair. This hose clamp is a genuine OEM part and is sold individually.

Inlet hose - 5 ft (hose, inlet)

This hose can handle hot or cold water and is five feet long.

Screw (screw, 10-16 x 1/2)

This screw is sold individually.

Water inlet hose washer (washer, 1-1/16 x 5/8)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Water inlet valve (valve, water mxing servcd only as complte assm)

This valve has two ports for water to enter. This valve is compatible with a half inch ID hose and it has two 3/4-11x1/2 NHT hose threads.

Hose washer kit (screen, filter)

Washer fill hose gasket and screen. This is a set of 4.

Screw, ground (screw, 10-16 x 1/2)

Screw (screw, 10-16 x 1-1/2)

This screw is sold individually.

Knob, water temperture (knob control)

Clip

Wire clamp (clamp, harness)

Switch, water termperature (switch, temperature)

Washer (lockwasher)

No longer available

This part is discontinued from the manufacturer and is no longer available to purchase.